tree ae4fbfdd9bde46ba24f761e9fca8d3a3fdbe623e
parent fd247447c1d94a79d5cfc647430784306b3a8323
author Rafael J. Wysocki <rjw@sisk.pl> 1275986985 +0200
committer Len Brown <len.brown@intel.com> 1276317905 -0400

ACPI / ACPICA: Avoid writing full enable masks to GPE registers

ACPICA uses acpi_hw_write_gpe_enable_reg() to re-enable a GPE after
an event signaled by it has been handled.  However, this function
writes the entire GPE enable mask to the GPE's enable register which
may not be correct.  Namely, if one of the other GPEs in the same
register was previously enabled by acpi_enable_gpe() and subsequently
disabled using acpi_set_gpe(), acpi_hw_write_gpe_enable_reg() will
re-enable it along with the target GPE.

To fix this issue rework acpi_hw_write_gpe_enable_reg() so that it
calls acpi_hw_low_set_gpe() with a special action value,
ACPI_GPE_COND_ENABLE, that will make it only enable the GPE if the
corresponding bit in its register's enable_for_run mask is set.

Signed-off-by: Rafael J. Wysocki <rjw@sisk.pl>
Signed-off-by: Len Brown <len.brown@intel.com>