Btrfs: account for missing devices in RAID allocation profiles
When we mount in RAID degraded mode without adding a new device to
replace the failed one, we can end up using the wrong RAID flags for
allocations.
This results in strange combinations of block groups (raid1 in a raid10
filesystem) and corruptions when we try to allocate blocks from single
spindle chunks on drives that are actually missing.
The first device has two small 4MB chunks in it that mkfs creates and
these are usually unused in a raid1 or raid10 setup. But, in -o degraded,
the allocator will fall back to these because the mask of desired raid groups
isn't correct.
The fix here is to count the missing devices as we build up the list
of devices in the system. This count is used when picking the
raid level to make sure we continue using the same levels that were
in place before we lost a drive.
Signed-off-by: Chris Mason <chris.mason@oracle.com>
diff --git a/fs/btrfs/volumes.h b/fs/btrfs/volumes.h
index 31b0fab..a668c01 100644
--- a/fs/btrfs/volumes.h
+++ b/fs/btrfs/volumes.h
@@ -45,6 +45,7 @@
int barriers;
int writeable;
int in_fs_metadata;
+ int missing;
spinlock_t io_lock;
@@ -94,6 +95,7 @@
u64 num_devices;
u64 open_devices;
u64 rw_devices;
+ u64 missing_devices;
u64 total_rw_bytes;
struct block_device *latest_bdev;