| # |
| # Acorn Network device configuration |
| # These are for Acorn's Expansion card network interfaces |
| # |
| config ARM_AM79C961A |
| bool "ARM EBSA110 AM79C961A support" |
| depends on ARM && ARCH_EBSA110 |
| select CRC32 |
| help |
| If you wish to compile a kernel for the EBSA-110, then you should |
| always answer Y to this. |
| |
| config ARM_ETHER1 |
| tristate "Acorn Ether1 support" |
| depends on ARM && ARCH_ACORN |
| help |
| If you have an Acorn system with one of these (AKA25) network cards, |
| you should say Y to this option if you wish to use it with Linux. |
| |
| config ARM_ETHER3 |
| tristate "Acorn/ANT Ether3 support" |
| depends on ARM && ARCH_ACORN |
| help |
| If you have an Acorn system with one of these network cards, you |
| should say Y to this option if you wish to use it with Linux. |
| |
| config ARM_ETHERH |
| tristate "I-cubed EtherH/ANT EtherM support" |
| depends on ARM && ARCH_ACORN |
| select CRC32 |
| help |
| If you have an Acorn system with one of these network cards, you |
| should say Y to this option if you wish to use it with Linux. |
| |
| config ARM_AT91_ETHER |
| tristate "AT91RM9200 Ethernet support" |
| depends on ARM && ARCH_AT91RM9200 |
| select MII |
| help |
| If you wish to compile a kernel for the AT91RM9200 and enable |
| ethernet support, then you should always answer Y to this. |
| |
| config EP93XX_ETH |
| tristate "EP93xx Ethernet support" |
| depends on ARM && ARCH_EP93XX |
| help |
| This is a driver for the ethernet hardware included in EP93xx CPUs. |
| Say Y if you are building a kernel for EP93xx based devices. |