gxfb: clean up register definitions
This does the following in preparation for register saving:
- moves the register definitions from video_gx.h and display_gx.h into
gxfb.h.
- renames GX_* registers to match their section (ie, VP_).
- renames register bitfields to match the data sheet (ie,
DC_DCFG_TGEN -> DC_DISPLAY_CFG_TGEN).
- for DC registers, rather than defining to specific addresses, use
an enum to number them sequentially and just multiply by 4(bytes) to
access them (in read_dc/write_dc).
- for VP and FP registers, use an enum and multiple by 8 (bytes). They're
64bit registers.
Signed-off-by: Andres Salomon <dilinger@debian.org>
Cc: Jordan Crouse <jordan.crouse@amd.com>
Cc: "Antonino A. Daplas" <adaplas@pol.net>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
diff --git a/drivers/video/geode/gxfb.h b/drivers/video/geode/gxfb.h
index 42fa10d..d408ad3 100644
--- a/drivers/video/geode/gxfb.h
+++ b/drivers/video/geode/gxfb.h
@@ -13,35 +13,243 @@
#include <linux/io.h>
+/* Display Controller registers (table 6-38 from the data book) */
+enum dc_registers {
+ DC_UNLOCK = 0,
+ DC_GENERAL_CFG,
+ DC_DISPLAY_CFG,
+ DC_RSVD_0,
+
+ DC_FB_ST_OFFSET,
+ DC_CB_ST_OFFSET,
+ DC_CURS_ST_OFFSET,
+ DC_ICON_ST_OFFSET,
+
+ DC_VID_Y_ST_OFFSET,
+ DC_VID_U_ST_OFFSET,
+ DC_VID_V_ST_OFFSET,
+ DC_RSVD_1,
+
+ DC_LINE_SIZE,
+ DC_GFX_PITCH,
+ DC_VID_YUV_PITCH,
+ DC_RSVD_2,
+
+ DC_H_ACTIVE_TIMING,
+ DC_H_BLANK_TIMING,
+ DC_H_SYNC_TIMING,
+ DC_RSVD_3,
+
+ DC_V_ACTIVE_TIMING,
+ DC_V_BLANK_TIMING,
+ DC_V_SYNC_TIMING,
+ DC_RSVD_4,
+
+ DC_CURSOR_X,
+ DC_CURSOR_Y,
+ DC_ICON_X,
+ DC_LINE_CNT,
+
+ DC_PAL_ADDRESS,
+ DC_PAL_DATA,
+ DC_DFIFO_DIAG,
+ DC_CFIFO_DIAG,
+
+ DC_VID_DS_DELTA,
+ DC_GLIU0_MEM_OFFSET,
+ DC_RSVD_5,
+ DC_DV_ACC, /* 0x8c */
+};
+
+#define DC_UNLOCK_LOCK 0x00000000
+#define DC_UNLOCK_UNLOCK 0x00004758 /* magic value */
+
+#define DC_GENERAL_CFG_YUVM (1 << 20)
+#define DC_GENERAL_CFG_VDSE (1 << 19)
+#define DC_GENERAL_CFG_DFHPEL_SHIFT 12
+#define DC_GENERAL_CFG_DFHPSL_SHIFT 8
+#define DC_GENERAL_CFG_DECE (1 << 6)
+#define DC_GENERAL_CFG_CMPE (1 << 5)
+#define DC_GENERAL_CFG_VIDE (1 << 3)
+#define DC_GENERAL_CFG_ICNE (1 << 2)
+#define DC_GENERAL_CFG_CURE (1 << 1)
+#define DC_GENERAL_CFG_DFLE (1 << 0)
+
+#define DC_DISPLAY_CFG_A20M (1 << 31)
+#define DC_DISPLAY_CFG_A18M (1 << 30)
+#define DC_DISPLAY_CFG_PALB (1 << 25)
+#define DC_DISPLAY_CFG_DISP_MODE_24BPP (1 << 9)
+#define DC_DISPLAY_CFG_DISP_MODE_16BPP (1 << 8)
+#define DC_DISPLAY_CFG_DISP_MODE_8BPP (0)
+#define DC_DISPLAY_CFG_VDEN (1 << 4)
+#define DC_DISPLAY_CFG_GDEN (1 << 3)
+#define DC_DISPLAY_CFG_TGEN (1 << 0)
+
+
+/*
+ * Video Processor registers (table 6-54).
+ * There is space for 64 bit values, but we never use more than the
+ * lower 32 bits. The actual register save/restore code only bothers
+ * to restore those 32 bits.
+ */
+enum vp_registers {
+ VP_VCFG = 0,
+ VP_DCFG,
+
+ VP_VX,
+ VP_VY,
+
+ VP_VS,
+ VP_VCK,
+
+ VP_VCM,
+ VP_GAR,
+
+ VP_GDR,
+ VP_RSVD_0,
+
+ VP_MISC,
+ VP_CCS,
+
+ VP_RSVD_1,
+ VP_RSVD_2,
+
+ VP_RSVD_3,
+ VP_VDC,
+
+ VP_VCO,
+ VP_CRC,
+
+ VP_CRC32,
+ VP_VDE,
+
+ VP_CCK,
+ VP_CCM,
+
+ VP_CC1,
+ VP_CC2,
+
+ VP_A1X,
+ VP_A1Y,
+
+ VP_A1C,
+ VP_A1T,
+
+ VP_A2X,
+ VP_A2Y,
+
+ VP_A2C,
+ VP_A2T,
+
+ VP_A3X,
+ VP_A3Y,
+
+ VP_A3C,
+ VP_A3T,
+
+ VP_VRR,
+ VP_AWT,
+
+ VP_VTM, /* 0x130 */
+};
+
+#define VP_VCFG_VID_EN (1 << 0)
+
+#define VP_DCFG_DAC_VREF (1 << 26)
+#define VP_DCFG_GV_GAM (1 << 21)
+#define VP_DCFG_VG_CK (1 << 20)
+#define VP_DCFG_CRT_SYNC_SKW_DEFAULT (1 << 16)
+#define VP_DCFG_CRT_SYNC_SKW ((1 << 14) | (1 << 15) | (1 << 16))
+#define VP_DCFG_CRT_VSYNC_POL (1 << 9)
+#define VP_DCFG_CRT_HSYNC_POL (1 << 8)
+#define VP_DCFG_FP_DATA_EN (1 << 7) /* undocumented */
+#define VP_DCFG_FP_PWR_EN (1 << 6) /* undocumented */
+#define VP_DCFG_DAC_BL_EN (1 << 3)
+#define VP_DCFG_VSYNC_EN (1 << 2)
+#define VP_DCFG_HSYNC_EN (1 << 1)
+#define VP_DCFG_CRT_EN (1 << 0)
+
+#define VP_MISC_GAM_EN (1 << 0)
+#define VP_MISC_DACPWRDN (1 << 10)
+#define VP_MISC_APWRDN (1 << 11)
+
+
+/*
+ * Flat Panel registers (table 6-55).
+ * Also 64 bit registers; see above note about 32-bit handling.
+ */
+
+/* we're actually in the VP register space, starting at address 0x400 */
+#define VP_FP_START 0x400
+
+enum fp_registers {
+ FP_PT1 = 0,
+ FP_PT2,
+
+ FP_PM,
+ FP_DFC,
+
+ FP_BLFSR,
+ FP_RLFSR,
+
+ FP_FMI,
+ FP_FMD,
+
+ FP_RSVD_0,
+ FP_DCA,
+
+ FP_DMD,
+ FP_CRC,
+
+ FP_FBB, /* 0x460 */
+};
+
+#define FP_PT1_VSIZE_SHIFT 16 /* undocumented? */
+#define FP_PT1_VSIZE_MASK 0x7FF0000 /* undocumented? */
+
+#define FP_PT2_HSP (1 << 22)
+#define FP_PT2_VSP (1 << 23)
+
+#define FP_PM_P (1 << 24) /* panel power on */
+#define FP_PM_PANEL_PWR_UP (1 << 3) /* r/o */
+#define FP_PM_PANEL_PWR_DOWN (1 << 2) /* r/o */
+#define FP_PM_PANEL_OFF (1 << 1) /* r/o */
+#define FP_PM_PANEL_ON (1 << 0) /* r/o */
+
+#define FP_DFC_NFI ((1 << 4) | (1 << 5) | (1 << 6))
+
+
+/* register access functions */
+
static inline uint32_t read_dc(struct geodefb_par *par, int reg)
{
- return readl(par->dc_regs + reg);
+ return readl(par->dc_regs + 4*reg);
}
static inline void write_dc(struct geodefb_par *par, int reg, uint32_t val)
{
- writel(val, par->dc_regs + reg);
-
+ writel(val, par->dc_regs + 4*reg);
}
+
static inline uint32_t read_vp(struct geodefb_par *par, int reg)
{
- return readl(par->vid_regs + reg);
+ return readl(par->vid_regs + 8*reg);
}
static inline void write_vp(struct geodefb_par *par, int reg, uint32_t val)
{
- writel(val, par->vid_regs + reg);
+ writel(val, par->vid_regs + 8*reg);
}
static inline uint32_t read_fp(struct geodefb_par *par, int reg)
{
- return readl(par->vid_regs + reg);
+ return readl(par->vid_regs + 8*reg + VP_FP_START);
}
static inline void write_fp(struct geodefb_par *par, int reg, uint32_t val)
{
- writel(val, par->vid_regs + reg);
+ writel(val, par->vid_regs + 8*reg + VP_FP_START);
}
#endif