[PATCH] paravirt: optimize ptep establish for pae
The ptep_establish macro is only used on user-level PTEs, for P->P mapping
changes. Since these always happen under protection of the pagetable lock,
the strong synchronization of a 64-bit cmpxchg is not needed, in fact, not
even a lock prefix needs to be used. We can simply instead clear the P-bit,
followed by a normal set. The write ordering is still important to avoid the
possibility of the TLB snooping a partially written PTE and getting a bad
mapping installed.
Signed-off-by: Zachary Amsden <zach@vmware.com>
Cc: Rusty Russell <rusty@rustcorp.com.au>
Cc: Jeremy Fitzhardinge <jeremy@xensource.com>
Cc: Andi Kleen <ak@suse.de>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
diff --git a/include/asm-i386/pgtable-2level.h b/include/asm-i386/pgtable-2level.h
index 201c86a..8d8d3b9 100644
--- a/include/asm-i386/pgtable-2level.h
+++ b/include/asm-i386/pgtable-2level.h
@@ -16,6 +16,7 @@
#define set_pte(pteptr, pteval) (*(pteptr) = pteval)
#define set_pte_at(mm,addr,ptep,pteval) set_pte(ptep,pteval)
#define set_pte_atomic(pteptr, pteval) set_pte(pteptr,pteval)
+#define set_pte_present(mm,addr,ptep,pteval) set_pte_at(mm,addr,ptep,pteval)
#define set_pmd(pmdptr, pmdval) (*(pmdptr) = (pmdval))
#define pte_clear(mm,addr,xp) do { set_pte_at(mm, addr, xp, __pte(0)); } while (0)
diff --git a/include/asm-i386/pgtable-3level.h b/include/asm-i386/pgtable-3level.h
index 0d89917..7c58deb 100644
--- a/include/asm-i386/pgtable-3level.h
+++ b/include/asm-i386/pgtable-3level.h
@@ -58,6 +58,21 @@
}
#define set_pte_at(mm,addr,ptep,pteval) set_pte(ptep,pteval)
+/*
+ * Since this is only called on user PTEs, and the page fault handler
+ * must handle the already racy situation of simultaneous page faults,
+ * we are justified in merely clearing the PTE present bit, followed
+ * by a set. The ordering here is important.
+ */
+static inline void set_pte_present(struct mm_struct *mm, unsigned long addr, pte_t *ptep, pte_t pte)
+{
+ ptep->pte_low = 0;
+ smp_wmb();
+ ptep->pte_high = pte.pte_high;
+ smp_wmb();
+ ptep->pte_low = pte.pte_low;
+}
+
#define __HAVE_ARCH_SET_PTE_ATOMIC
#define set_pte_atomic(pteptr,pteval) \
set_64bit((unsigned long long *)(pteptr),pte_val(pteval))
diff --git a/include/asm-i386/pgtable.h b/include/asm-i386/pgtable.h
index ee9696d..8cb708a 100644
--- a/include/asm-i386/pgtable.h
+++ b/include/asm-i386/pgtable.h
@@ -269,6 +269,17 @@
#define __HAVE_ARCH_PTEP_TEST_AND_CLEAR_DIRTY
#define __HAVE_ARCH_PTEP_TEST_AND_CLEAR_YOUNG
+/*
+ * Rules for using ptep_establish: the pte MUST be a user pte, and
+ * must be a present->present transition.
+ */
+#define __HAVE_ARCH_PTEP_ESTABLISH
+#define ptep_establish(vma, address, ptep, pteval) \
+do { \
+ set_pte_present((vma)->vm_mm, address, ptep, pteval); \
+ flush_tlb_page(vma, address); \
+} while (0)
+
#define __HAVE_ARCH_PTEP_CLEAR_DIRTY_FLUSH
#define ptep_clear_flush_dirty(vma, address, ptep) \
({ \