w1_ds2433: clear the validcrc flag after a write
The w1_ds2433 driver does not read from the hardware if the CRC was valid
on the last read. The validcrc flag should be cleared after a write so
that the new value can be read.
Signed-off-by: Ben Gardner <gardner.ben@gmail.com>
Signed-off-by: Evgeniy Polyakov <johnpol@2ka.mipt.ru>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
diff --git a/drivers/w1/slaves/w1_ds2433.c b/drivers/w1/slaves/w1_ds2433.c
index 858c16a..1394471 100644
--- a/drivers/w1/slaves/w1_ds2433.c
+++ b/drivers/w1/slaves/w1_ds2433.c
@@ -156,6 +156,9 @@
*/
static int w1_f23_write(struct w1_slave *sl, int addr, int len, const u8 *data)
{
+#ifdef CONFIG_W1_SLAVE_DS2433_CRC
+ struct w1_f23_data *f23 = sl->family_data;
+#endif
u8 wrbuf[4];
u8 rdbuf[W1_PAGE_SIZE + 3];
u8 es = (addr + len - 1) & 0x1f;
@@ -196,7 +199,9 @@
/* Reset the bus to wake up the EEPROM (this may not be needed) */
w1_reset_bus(sl->master);
-
+#ifdef CONFIG_W1_SLAVE_DS2433_CRC
+ f23->validcrc &= ~(1 << (addr >> W1_PAGE_BITS));
+#endif
return 0;
}