i2c-ocores: Can add I2C devices to the bus
There is sometimes a need for the ocores driver to add devices to the
bus when installed.
i2c_register_board_info can not always be used, because the I2C devices
are not known at an early state, they could for instance be connected
on a I2C bus on a PCI device which has the Open Cores IP.
i2c_new_device can not be used in all cases either since the resulting
bus nummer might be unknown.
The solution is the pass a list of I2C devices in the platform data to
the Open Cores driver. This is useful for MFD drivers.
Signed-off-by: Richard Röjfors <richard.rojfors.ext@mocean-labs.com>
Signed-off-by: Ben Dooks <ben-linux@fluff.org>
diff --git a/drivers/i2c/busses/i2c-ocores.c b/drivers/i2c/busses/i2c-ocores.c
index e5193bf..3542c6b 100644
--- a/drivers/i2c/busses/i2c-ocores.c
+++ b/drivers/i2c/busses/i2c-ocores.c
@@ -216,6 +216,7 @@
struct ocores_i2c_platform_data *pdata;
struct resource *res, *res2;
int ret;
+ int i;
res = platform_get_resource(pdev, IORESOURCE_MEM, 0);
if (!res)
@@ -271,6 +272,10 @@
goto add_adapter_failed;
}
+ /* add in known devices to the bus */
+ for (i = 0; i < pdata->num_devices; i++)
+ i2c_new_device(&i2c->adap, pdata->devices + i);
+
return 0;
add_adapter_failed: