EHCI: HSIC: Set RUN/STOP bit after PORT_RESUME gets cleared
There is a possibility of HSIC phy getting locked up if RUN/STOP
bit is set before finishing the resume signaling. Hence do not
set the RUN/STOP bit before setting PORT_RESUME bit. Since
PORT_RESUME bit gets cleared automatically by HSIC HW after bus
resume is completed, need to set RUN/STOP bit right after that.
CRs-Fixed: 372145
Change-Id: Icb9effefe14c10f13cfbb3d8f1840c8bdd96aea4
Signed-off-by: Hemant Kumar <hemantk@codeaurora.org>
3 files changed