spi: Move at25 (for SPI eeproms) to /drivers/misc/eeprom
Signed-off-by: Wolfram Sang <w.sang@pengutronix.de>
Signed-off-by: Jean Delvare <khali@linux-fr.org>
diff --git a/drivers/misc/eeprom/Kconfig b/drivers/misc/eeprom/Kconfig
index 3d31b66..5bf3c92 100644
--- a/drivers/misc/eeprom/Kconfig
+++ b/drivers/misc/eeprom/Kconfig
@@ -26,6 +26,17 @@
This driver can also be built as a module. If so, the module
will be called at24.
+config SPI_AT25
+ tristate "SPI EEPROMs from most vendors"
+ depends on SPI && SYSFS
+ help
+ Enable this driver to get read/write support to most SPI EEPROMs,
+ after you configure the board init code to know about each eeprom
+ on your target board.
+
+ This driver can also be built as a module. If so, the module
+ will be called at25.
+
config SENSORS_EEPROM
tristate "Old I2C EEPROM reader"
depends on I2C && EXPERIMENTAL
diff --git a/drivers/misc/eeprom/Makefile b/drivers/misc/eeprom/Makefile
index a3dad28..a4fb5cf 100644
--- a/drivers/misc/eeprom/Makefile
+++ b/drivers/misc/eeprom/Makefile
@@ -1,2 +1,3 @@
obj-$(CONFIG_AT24) += at24.o
+obj-$(CONFIG_SPI_AT25) += at25.o
obj-$(CONFIG_SENSORS_EEPROM) += eeprom.o
diff --git a/drivers/spi/at25.c b/drivers/misc/eeprom/at25.c
similarity index 100%
rename from drivers/spi/at25.c
rename to drivers/misc/eeprom/at25.c
diff --git a/drivers/spi/Kconfig b/drivers/spi/Kconfig
index 4a6fe01..83a185d 100644
--- a/drivers/spi/Kconfig
+++ b/drivers/spi/Kconfig
@@ -230,17 +230,6 @@
#
comment "SPI Protocol Masters"
-config SPI_AT25
- tristate "SPI EEPROMs from most vendors"
- depends on SYSFS
- help
- Enable this driver to get read/write support to most SPI EEPROMs,
- after you configure the board init code to know about each eeprom
- on your target board.
-
- This driver can also be built as a module. If so, the module
- will be called at25.
-
config SPI_SPIDEV
tristate "User mode SPI device driver support"
depends on EXPERIMENTAL
diff --git a/drivers/spi/Makefile b/drivers/spi/Makefile
index 5e9f521..5d04519 100644
--- a/drivers/spi/Makefile
+++ b/drivers/spi/Makefile
@@ -33,7 +33,6 @@
# ... add above this line ...
# SPI protocol drivers (device/link on bus)
-obj-$(CONFIG_SPI_AT25) += at25.o
obj-$(CONFIG_SPI_SPIDEV) += spidev.o
obj-$(CONFIG_SPI_TLE62X0) += tle62x0.o
# ... add above this line ...