pcmcia: move Vpp setup to struct pcmcia_device
Some drivers prefer to explicitly set Vpp. Instead of passing the
voltage inside config_req_t, store it in struct pcmcia_device.
CC: linux-ide@vger.kernel.org
CC: netdev@vger.kernel.org
CC: linux-mtd@lists.infradead.org
CC: linux-wireless@vger.kernel.org
CC: linux-serial@vger.kernel.org
CC: linux-usb@vger.kernel.org
CC: linux-scsi@vger.kernel.org
Acked-by: Gustavo F. Padovan <padovan@profusion.mobi> (for drivers/bluetooth)
Tested-by: Wolfram Sang <w.sang@pengutronix.de>
Signed-off-by: Dominik Brodowski <linux@dominikbrodowski.net>
diff --git a/drivers/scsi/pcmcia/nsp_cs.c b/drivers/scsi/pcmcia/nsp_cs.c
index e872e06..50574e8 100644
--- a/drivers/scsi/pcmcia/nsp_cs.c
+++ b/drivers/scsi/pcmcia/nsp_cs.c
@@ -1624,10 +1624,10 @@
}
if (cfg->vpp1.present & (1 << CISTPL_POWER_VNOM)) {
- p_dev->conf.Vpp =
+ p_dev->vpp =
cfg->vpp1.param[CISTPL_POWER_VNOM] / 10000;
} else if (dflt->vpp1.present & (1 << CISTPL_POWER_VNOM)) {
- p_dev->conf.Vpp =
+ p_dev->vpp =
dflt->vpp1.param[CISTPL_POWER_VNOM] / 10000;
}
@@ -1749,8 +1749,8 @@
/* Finally, report what we've done */
printk(KERN_INFO "nsp_cs: index 0x%02x: ",
link->conf.ConfigIndex);
- if (link->conf.Vpp) {
- printk(", Vpp %d.%d", link->conf.Vpp/10, link->conf.Vpp%10);
+ if (link->vpp) {
+ printk(", Vpp %d.%d", link->vpp/10, link->vpp%10);
}
if (link->conf.Attributes & CONF_ENABLE_IRQ) {
printk(", irq %d", link->irq);