[PATCH] bcm43xx: Drain TX status before starting IRQs
Drain the Microcode TX-status-FIFO before we enable IRQs.
This is required, because the FIFO may still have entries left
from a previous run. Those would immediately fire after enabling
IRQs and would lead to an oops in the DMA TXstatus handling code.
Signed-off-by: Michael Buesch <mb@bu3sch.de>
Signed-off-by: Larry Finger <Larry.Finger@lwfinger.net>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/bcm43xx/bcm43xx_main.c b/drivers/net/wireless/bcm43xx/bcm43xx_main.c
index 65edb56..62c2ff8 100644
--- a/drivers/net/wireless/bcm43xx/bcm43xx_main.c
+++ b/drivers/net/wireless/bcm43xx/bcm43xx_main.c
@@ -1463,6 +1463,23 @@
}
}
+static void drain_txstatus_queue(struct bcm43xx_private *bcm)
+{
+ u32 dummy;
+
+ if (bcm->current_core->rev < 5)
+ return;
+ /* Read all entries from the microcode TXstatus FIFO
+ * and throw them away.
+ */
+ while (1) {
+ dummy = bcm43xx_read32(bcm, BCM43xx_MMIO_XMITSTAT_0);
+ if (!dummy)
+ break;
+ dummy = bcm43xx_read32(bcm, BCM43xx_MMIO_XMITSTAT_1);
+ }
+}
+
static void bcm43xx_generate_noise_sample(struct bcm43xx_private *bcm)
{
bcm43xx_shm_write16(bcm, BCM43xx_SHM_SHARED, 0x408, 0x7F7F);
@@ -3532,6 +3549,7 @@
bcm43xx_macfilter_clear(bcm, BCM43xx_MACFILTER_ASSOC);
bcm43xx_macfilter_set(bcm, BCM43xx_MACFILTER_SELF, (u8 *)(bcm->net_dev->dev_addr));
bcm43xx_security_init(bcm);
+ drain_txstatus_queue(bcm);
ieee80211softmac_start(bcm->net_dev);
/* Let's go! Be careful after enabling the IRQs.