ASoC: Convert WM8903 to table based DAPM setup
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
Acked-by: Liam Girdwood <lrg@ti.com>
diff --git a/sound/soc/codecs/wm8903.c b/sound/soc/codecs/wm8903.c
index ae1cadf..a739e09 100644
--- a/sound/soc/codecs/wm8903.c
+++ b/sound/soc/codecs/wm8903.c
@@ -926,7 +926,7 @@
SND_SOC_DAPM_SUPPLY("CLK_SYS", WM8903_CLOCK_RATES_2, 2, 0, NULL, 0),
};
-static const struct snd_soc_dapm_route intercon[] = {
+static const struct snd_soc_dapm_route wm8903_intercon[] = {
{ "CLK_DSP", NULL, "CLK_SYS" },
{ "Mic Bias", NULL, "CLK_SYS" },
@@ -1079,17 +1079,6 @@
{ "Right Line Output PGA", NULL, "Charge Pump" },
};
-static int wm8903_add_widgets(struct snd_soc_codec *codec)
-{
- struct snd_soc_dapm_context *dapm = &codec->dapm;
-
- snd_soc_dapm_new_controls(dapm, wm8903_dapm_widgets,
- ARRAY_SIZE(wm8903_dapm_widgets));
- snd_soc_dapm_add_routes(dapm, intercon, ARRAY_SIZE(intercon));
-
- return 0;
-}
-
static int wm8903_set_bias_level(struct snd_soc_codec *codec,
enum snd_soc_bias_level level)
{
@@ -2020,7 +2009,6 @@
snd_soc_add_controls(codec, wm8903_snd_controls,
ARRAY_SIZE(wm8903_snd_controls));
- wm8903_add_widgets(codec);
wm8903_init_gpio(codec);
@@ -2046,6 +2034,10 @@
.reg_cache_default = wm8903_reg_defaults,
.volatile_register = wm8903_volatile_register,
.seq_notifier = wm8903_seq_notifier,
+ .dapm_widgets = wm8903_dapm_widgets,
+ .num_dapm_widgets = ARRAY_SIZE(wm8903_dapm_widgets),
+ .dapm_routes = wm8903_intercon,
+ .num_dapm_routes = ARRAY_SIZE(wm8903_intercon),
};
#if defined(CONFIG_I2C) || defined(CONFIG_I2C_MODULE)