[TG3]: ethtool always report port is TP.
Even with fiber cards ethtool reports that the connected port is TP,
the patch fix this.
Signed-off-by: Karsten Keil <kkeil@suse.de>
Acked-by: Michael Chan <mchan@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/tg3.c b/drivers/net/tg3.c
index 2bd9592..e1b33a2 100644
--- a/drivers/net/tg3.c
+++ b/drivers/net/tg3.c
@@ -7653,21 +7653,23 @@
cmd->supported |= (SUPPORTED_1000baseT_Half |
SUPPORTED_1000baseT_Full);
- if (!(tp->tg3_flags2 & TG3_FLG2_ANY_SERDES))
+ if (!(tp->tg3_flags2 & TG3_FLG2_ANY_SERDES)) {
cmd->supported |= (SUPPORTED_100baseT_Half |
SUPPORTED_100baseT_Full |
SUPPORTED_10baseT_Half |
SUPPORTED_10baseT_Full |
SUPPORTED_MII);
- else
+ cmd->port = PORT_TP;
+ } else {
cmd->supported |= SUPPORTED_FIBRE;
+ cmd->port = PORT_FIBRE;
+ }
cmd->advertising = tp->link_config.advertising;
if (netif_running(dev)) {
cmd->speed = tp->link_config.active_speed;
cmd->duplex = tp->link_config.active_duplex;
}
- cmd->port = 0;
cmd->phy_address = PHY_ADDR;
cmd->transceiver = 0;
cmd->autoneg = tp->link_config.autoneg;