[PATCH] libata: implement ATA_EHI_PRINTINFO
Implement ehi flag ATA_EHI_PRINTINFO. This flag is set when device
configuration needs to print out device info. This used to be handled
by @print_info argument to ata_dev_configure() but LLDs also need to
know about it in ->dev_config() callback.
This patch replaces @print_info w/ ATA_EHI_PRINTINFO and make sata_sil
print workaround messages only on the initial configuration.
Signed-off-by: Tejun Heo <htejun@gmail.com>
Signed-off-by: Jeff Garzik <jeff@garzik.org>
diff --git a/drivers/ata/libata-core.c b/drivers/ata/libata-core.c
index 315f468..e294731 100644
--- a/drivers/ata/libata-core.c
+++ b/drivers/ata/libata-core.c
@@ -1377,7 +1377,6 @@
/**
* ata_dev_configure - Configure the specified ATA/ATAPI device
* @dev: Target device to configure
- * @print_info: Enable device info printout
*
* Configure @dev according to @dev->id. Generic and low-level
* driver specific fixups are also applied.
@@ -1388,9 +1387,10 @@
* RETURNS:
* 0 on success, -errno otherwise
*/
-int ata_dev_configure(struct ata_device *dev, int print_info)
+int ata_dev_configure(struct ata_device *dev)
{
struct ata_port *ap = dev->ap;
+ int print_info = ap->eh_context.i.flags & ATA_EHI_PRINTINFO;
const u16 *id = dev->id;
unsigned int xfer_mask;
char revbuf[7]; /* XYZ-99\0 */
@@ -1638,7 +1638,9 @@
if (rc)
goto fail;
- rc = ata_dev_configure(dev, 1);
+ ap->eh_context.i.flags |= ATA_EHI_PRINTINFO;
+ rc = ata_dev_configure(dev);
+ ap->eh_context.i.flags &= ~ATA_EHI_PRINTINFO;
if (rc)
goto fail;
}
@@ -3045,7 +3047,7 @@
memcpy(dev->id, id, sizeof(id[0]) * ATA_ID_WORDS);
/* configure device according to the new ID */
- rc = ata_dev_configure(dev, 0);
+ rc = ata_dev_configure(dev);
if (rc == 0)
return 0;