diag: Add support for sending DIAG_CTRL_MSG_DIAG_MODE
Currently, APPS diag does not support sending mode control message
to any processor. This command notifies the diag software on the
peripheral if it is to run in real-time or non-real-time mode. Add
support for sending the mode control message to the modem and wcnss.
Change-Id: Ia390e7f8fbb4601b5f62656cdc53ab5f8cc89826
Signed-off-by: Dixon Peterson <dixonp@codeaurora.org>
diff --git a/drivers/char/diag/diagfwd_bridge.c b/drivers/char/diag/diagfwd_bridge.c
index b934805..475f5ba 100644
--- a/drivers/char/diag/diagfwd_bridge.c
+++ b/drivers/char/diag/diagfwd_bridge.c
@@ -65,7 +65,9 @@
driver->in_busy_smux = 0;
diagfwd_connect_smux();
} else {
- if (diag_hsic[index].hsic_device_enabled) {
+ if (diag_hsic[index].hsic_device_enabled &&
+ (driver->logging_mode != MEMORY_DEVICE_MODE ||
+ diag_hsic[index].hsic_data_requested)) {
diag_hsic[index].in_busy_hsic_read_on_device = 0;
diag_hsic[index].in_busy_hsic_write = 0;
/* If the HSIC (diag_bridge) platform
@@ -126,20 +128,24 @@
usb_diag_free_req(diag_bridge[i].ch);
}
- if (i == SMUX && driver->diag_smux_enabled &&
+ if (i == SMUX) {
+ if (driver->diag_smux_enabled &&
driver->logging_mode == USB_MODE) {
- driver->in_busy_smux = 1;
- driver->lcid = LCID_INVALID;
- driver->smux_connected = 0;
- /* Turn off communication over usb and smux */
- msm_smux_close(LCID_VALID);
+ driver->in_busy_smux = 1;
+ driver->lcid = LCID_INVALID;
+ driver->smux_connected = 0;
+ /*
+ * Turn off communication over usb
+ * and smux
+ */
+ msm_smux_close(LCID_VALID);
+ }
} else {
if (diag_hsic[i].hsic_device_enabled &&
- driver->logging_mode !=
- MEMORY_DEVICE_MODE) {
+ (driver->logging_mode != MEMORY_DEVICE_MODE
+ || !diag_hsic[i].hsic_data_requested)) {
diag_hsic[i].
- in_busy_hsic_read_on_device
- = 1;
+ in_busy_hsic_read_on_device = 1;
diag_hsic[i].in_busy_hsic_write = 1;
/* Turn off communication over usb
* and HSIC */