[media] it913x stop dual frontend attach in warm state with single devices
Stop dual frontend attach in warm state with single devices.
Since this is a no reconnect device this occurs only after a warm system
reboot.
Signed-off-by: Malcolm Priestley <tvboxspy@gmail.com>
Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>
diff --git a/drivers/media/dvb/dvb-usb/it913x.c b/drivers/media/dvb/dvb-usb/it913x.c
index 627fb819..ba3f11f 100644
--- a/drivers/media/dvb/dvb-usb/it913x.c
+++ b/drivers/media/dvb/dvb-usb/it913x.c
@@ -473,9 +473,12 @@
else
props->adapter[0].fe[0].stream.u.bulk.buffersize =
TS_BUFFER_SIZE_PID;
- if (it913x_config.dual_mode)
+ if (it913x_config.dual_mode) {
props->adapter[1].fe[0].stream.u.bulk.buffersize =
props->adapter[0].fe[0].stream.u.bulk.buffersize;
+ props->num_adapters = 2;
+ } else
+ props->num_adapters = 1;
ret = ite_firmware_select(udev, props);
@@ -499,10 +502,8 @@
if (ret != 0)
ret = it913x_wr_reg(udev, DEV_0,
GPIOH1_O, 0x0);
- props->num_adapters = 2;
}
- } else
- props->num_adapters = 1;
+ }
reg = it913x_read_reg(udev, IO_MUX_POWER_CLK);