diff --git a/drivers/usb/storage/initializers.h b/drivers/usb/storage/initializers.h
index 7372386..4c1b2bd 100644
--- a/drivers/usb/storage/initializers.h
+++ b/drivers/usb/storage/initializers.h
@@ -45,10 +45,6 @@
  * mode */
 int usb_stor_euscsi_init(struct us_data *us);
 
-#ifdef CONFIG_USB_STORAGE_SDDR09
-int sddr09_init(struct us_data *us);
-#endif
-
 /* This function is required to activate all four slots on the UCR-61S2B
  * flash reader */
 int usb_stor_ucr61s2b_init(struct us_data *us);
diff --git a/drivers/usb/storage/sddr09.c b/drivers/usb/storage/sddr09.c
index 0a6efae..6c379b6 100644
--- a/drivers/usb/storage/sddr09.c
+++ b/drivers/usb/storage/sddr09.c
@@ -214,6 +214,20 @@
  * The actual driver starts here.
  */
 
+struct sddr09_card_info {
+	unsigned long	capacity;	/* Size of card in bytes */
+	int		pagesize;	/* Size of page in bytes */
+	int		pageshift;	/* log2 of pagesize */
+	int		blocksize;	/* Size of block in pages */
+	int		blockshift;	/* log2 of blocksize */
+	int		blockmask;	/* 2^blockshift - 1 */
+	int		*lba_to_pba;	/* logical to physical map */
+	int		*pba_to_lba;	/* physical to logical map */
+	int		lbact;		/* number of available pages */
+	int		flags;
+#define	SDDR09_WP	1		/* write protected */
+};
+
 /*
  * On my 16MB card, control blocks have size 64 (16 real control bytes,
  * and 48 junk bytes). In reality of course the card uses 16 control bytes,
@@ -1342,27 +1356,51 @@
 	kfree(info->pba_to_lba);
 }
 
-static void
-sddr09_init_card_info(struct us_data *us) {
-	if (!us->extra) {
-		us->extra = kmalloc(sizeof(struct sddr09_card_info), GFP_NOIO);
-		if (us->extra) {
-			memset(us->extra, 0, sizeof(struct sddr09_card_info));
-			us->extra_destructor = sddr09_card_info_destructor;
-		}
+static int
+sddr09_common_init(struct us_data *us) {
+	int result;
+
+	/* set the configuration -- STALL is an acceptable response here */
+	if (us->pusb_dev->actconfig->desc.bConfigurationValue != 1) {
+		US_DEBUGP("active config #%d != 1 ??\n", us->pusb_dev
+				->actconfig->desc.bConfigurationValue);
+		return -EINVAL;
 	}
+
+	result = usb_reset_configuration(us->pusb_dev);
+	US_DEBUGP("Result of usb_reset_configuration is %d\n", result);
+	if (result == -EPIPE) {
+		US_DEBUGP("-- stall on control interface\n");
+	} else if (result != 0) {
+		/* it's not a stall, but another error -- time to bail */
+		US_DEBUGP("-- Unknown error.  Rejecting device\n");
+		return -EINVAL;
+	}
+
+	us->extra = kzalloc(sizeof(struct sddr09_card_info), GFP_NOIO);
+	if (!us->extra)
+		return -ENOMEM;
+	us->extra_destructor = sddr09_card_info_destructor;
+
+	nand_init_ecc();
+	return 0;
 }
 
+
 /*
  * This is needed at a very early stage. If this is not listed in the
  * unusual devices list but called from here then LUN 0 of the combo reader
  * is not recognized. But I do not know what precisely these calls do.
  */
 int
-sddr09_init(struct us_data *us) {
+usb_stor_sddr09_dpcm_init(struct us_data *us) {
 	int result;
 	unsigned char *data = us->iobuf;
 
+	result = sddr09_common_init(us);
+	if (result)
+		return result;
+
 	result = sddr09_send_command(us, 0x01, USB_DIR_IN, data, 2);
 	if (result != USB_STOR_TRANSPORT_GOOD) {
 		US_DEBUGP("sddr09_init: send_command fails\n");
@@ -1398,7 +1436,7 @@
 
 	// test unit ready
 
-	return USB_STOR_TRANSPORT_GOOD;		/* not result */
+	return 0;		/* not result */
 }
 
 /*
@@ -1427,13 +1465,6 @@
 	};
 
 	info = (struct sddr09_card_info *)us->extra;
-	if (!info) {
-		nand_init_ecc();
-		sddr09_init_card_info(us);
-		info = (struct sddr09_card_info *)us->extra;
-		if (!info)
-			return USB_STOR_TRANSPORT_ERROR;
-	}
 
 	if (srb->cmnd[0] == REQUEST_SENSE && havefakesense) {
 		/* for a faked command, we have to follow with a faked sense */
@@ -1606,3 +1637,10 @@
 	return USB_STOR_TRANSPORT_GOOD;
 }
 
+/*
+ * Initialization routine for the sddr09 subdriver
+ */
+int
+usb_stor_sddr09_init(struct us_data *us) {
+	return sddr09_common_init(us);
+}
diff --git a/drivers/usb/storage/sddr09.h b/drivers/usb/storage/sddr09.h
index c9d78d6..c03089a 100644
--- a/drivers/usb/storage/sddr09.h
+++ b/drivers/usb/storage/sddr09.h
@@ -31,18 +31,7 @@
 
 extern int sddr09_transport(struct scsi_cmnd *srb, struct us_data *us);
 
-struct sddr09_card_info {
-	unsigned long	capacity;	/* Size of card in bytes */
-	int		pagesize;	/* Size of page in bytes */
-	int		pageshift;	/* log2 of pagesize */
-	int		blocksize;	/* Size of block in pages */
-	int		blockshift;	/* log2 of blocksize */
-	int		blockmask;	/* 2^blockshift - 1 */
-	int		*lba_to_pba;	/* logical to physical map */
-	int		*pba_to_lba;	/* physical to logical map */
-	int		lbact;		/* number of available pages */
-	int		flags;
-#define	SDDR09_WP	1		/* write protected */
-};
+extern int usb_stor_sddr09_dpcm_init(struct us_data *us);
+extern int usb_stor_sddr09_init(struct us_data *us);
 
 #endif
diff --git a/drivers/usb/storage/unusual_devs.h b/drivers/usb/storage/unusual_devs.h
index 100f53c..be3c06d 100644
--- a/drivers/usb/storage/unusual_devs.h
+++ b/drivers/usb/storage/unusual_devs.h
@@ -284,14 +284,14 @@
 UNUSUAL_DEV(  0x04e6, 0x0003, 0x0000, 0x9999, 
 		"Sandisk",
 		"ImageMate SDDR09",
-		US_SC_SCSI, US_PR_EUSB_SDDR09, NULL,
-		US_FL_SINGLE_LUN ),
+		US_SC_SCSI, US_PR_EUSB_SDDR09, usb_stor_sddr09_init,
+		0),
 
 /* This entry is from Andries.Brouwer@cwi.nl */
 UNUSUAL_DEV(  0x04e6, 0x0005, 0x0100, 0x0208,
 		"SCM Microsystems",
 		"eUSB SmartMedia / CompactFlash Adapter",
-		US_SC_SCSI, US_PR_DPCM_USB, sddr09_init, 
+		US_SC_SCSI, US_PR_DPCM_USB, usb_stor_sddr09_dpcm_init,
 		0), 
 #endif
 
@@ -681,8 +681,8 @@
 UNUSUAL_DEV(  0x066b, 0x0105, 0x0100, 0x0100, 
 		"Olympus",
 		"Camedia MAUSB-2",
-		US_SC_SCSI, US_PR_EUSB_SDDR09, NULL,
-		US_FL_SINGLE_LUN ),
+		US_SC_SCSI, US_PR_EUSB_SDDR09, usb_stor_sddr09_init,
+		0),
 #endif
 
 /* Reported by Darsen Lu <darsen@micro.ee.nthu.edu.tw> */
@@ -747,8 +747,8 @@
 UNUSUAL_DEV(  0x0781, 0x0200, 0x0000, 0x9999, 
 		"Sandisk",
 		"ImageMate SDDR-09",
-		US_SC_SCSI, US_PR_EUSB_SDDR09, NULL,
-		US_FL_SINGLE_LUN ),
+		US_SC_SCSI, US_PR_EUSB_SDDR09, usb_stor_sddr09_init,
+		0),
 #endif
 
 #ifdef CONFIG_USB_STORAGE_FREECOM
diff --git a/drivers/usb/storage/usb.c b/drivers/usb/storage/usb.c
index ca02ae9..85c8c17 100644
--- a/drivers/usb/storage/usb.c
+++ b/drivers/usb/storage/usb.c
@@ -919,28 +919,6 @@
 	 */
 	get_device_info(us, id);
 
-#ifdef CONFIG_USB_STORAGE_SDDR09
-	if (us->protocol == US_PR_EUSB_SDDR09 ||
-			us->protocol == US_PR_DPCM_USB) {
-		/* set the configuration -- STALL is an acceptable response here */
-		if (us->pusb_dev->actconfig->desc.bConfigurationValue != 1) {
-			US_DEBUGP("active config #%d != 1 ??\n", us->pusb_dev
-				->actconfig->desc.bConfigurationValue);
-			goto BadDevice;
-		}
-		result = usb_reset_configuration(us->pusb_dev);
-
-		US_DEBUGP("Result of usb_reset_configuration is %d\n", result);
-		if (result == -EPIPE) {
-			US_DEBUGP("-- stall on control interface\n");
-		} else if (result != 0) {
-			/* it's not a stall, but another error -- time to bail */
-			US_DEBUGP("-- Unknown error.  Rejecting device\n");
-			goto BadDevice;
-		}
-	}
-#endif
-
 	/* Get the transport, protocol, and pipe settings */
 	result = get_transport(us);
 	if (result)