ixgbe: DCB, implement ieee_setapp dcbnl ops
Implement ieee_setapp dcbnl ops in ixgbe. This is required
to setup FCoE which requires dedicated resources. If the
app data is not for FCoE then no action is taken in ixgbe
except to add it to the dcb_app_list.
Signed-off-by: John Fastabend <john.r.fastabend@intel.com>
Tested-by: Ross Brattain <ross.b.brattain@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
diff --git a/drivers/net/ixgbe/ixgbe_dcb_nl.c b/drivers/net/ixgbe/ixgbe_dcb_nl.c
index d7c456f..8d139f7 100644
--- a/drivers/net/ixgbe/ixgbe_dcb_nl.c
+++ b/drivers/net/ixgbe/ixgbe_dcb_nl.c
@@ -709,6 +709,35 @@
return err;
}
+static int ixgbe_dcbnl_ieee_setapp(struct net_device *dev,
+ struct dcb_app *app)
+{
+ struct ixgbe_adapter *adapter = netdev_priv(dev);
+
+ if (!(adapter->dcbx_cap & DCB_CAP_DCBX_VER_IEEE))
+ return -EINVAL;
+#ifdef IXGBE_FCOE
+ if (app->selector == 1 && app->protocol == ETH_P_FCOE) {
+ if (adapter->fcoe.tc == app->priority)
+ goto setapp;
+
+ /* In IEEE mode map up to tc 1:1 */
+ adapter->fcoe.tc = app->priority;
+ adapter->fcoe.up = app->priority;
+
+ /* Force hardware reset required to push FCoE
+ * setup on {tx|rx}_rings
+ */
+ adapter->dcb_set_bitmap |= BIT_APP_UPCHG;
+ ixgbe_dcbnl_set_all(dev);
+ }
+
+setapp:
+#endif
+ dcb_setapp(dev, app);
+ return 0;
+}
+
static u8 ixgbe_dcbnl_getdcbx(struct net_device *dev)
{
struct ixgbe_adapter *adapter = netdev_priv(dev);
@@ -759,6 +788,7 @@
.ieee_setets = ixgbe_dcbnl_ieee_setets,
.ieee_getpfc = ixgbe_dcbnl_ieee_getpfc,
.ieee_setpfc = ixgbe_dcbnl_ieee_setpfc,
+ .ieee_setapp = ixgbe_dcbnl_ieee_setapp,
.getstate = ixgbe_dcbnl_get_state,
.setstate = ixgbe_dcbnl_set_state,
.getpermhwaddr = ixgbe_dcbnl_get_perm_hw_addr,