Blackfin: optimize double fault boot checking
This moves the double fault data used at boot time into a single struct
which can then easily be addressed with indexed loads rather than having
to explicitly load multiple addresses.
Signed-off-by: Mike Frysinger <vapier@gentoo.org>
diff --git a/arch/blackfin/mach-common/head.S b/arch/blackfin/mach-common/head.S
index 76de572..8b4d988 100644
--- a/arch/blackfin/mach-common/head.S
+++ b/arch/blackfin/mach-common/head.S
@@ -85,37 +85,25 @@
SSYNC;
/* in case of double faults, save a few things */
- p0.l = _init_retx;
- p0.h = _init_retx;
- R0 = RETX;
- [P0] = R0;
-
+ p1.l = _initial_pda;
+ p1.h = _initial_pda;
+ r4 = RETX;
#ifdef CONFIG_DEBUG_DOUBLEFAULT
/* Only save these if we are storing them,
* This happens here, since L1 gets clobbered
* below
*/
GET_PDA(p0, r0);
- r5 = [p0 + PDA_DF_RETX];
- p1.l = _init_saved_retx;
- p1.h = _init_saved_retx;
- [p1] = r5;
-
- r5 = [p0 + PDA_DF_DCPLB];
- p1.l = _init_saved_dcplb_fault_addr;
- p1.h = _init_saved_dcplb_fault_addr;
- [p1] = r5;
-
- r5 = [p0 + PDA_DF_ICPLB];
- p1.l = _init_saved_icplb_fault_addr;
- p1.h = _init_saved_icplb_fault_addr;
- [p1] = r5;
-
- r5 = [p0 + PDA_DF_SEQSTAT];
- p1.l = _init_saved_seqstat;
- p1.h = _init_saved_seqstat;
- [p1] = r5;
+ r0 = [p0 + PDA_DF_RETX];
+ r1 = [p0 + PDA_DF_DCPLB];
+ r2 = [p0 + PDA_DF_ICPLB];
+ r3 = [p0 + PDA_DF_SEQSTAT];
+ [p1 + PDA_INIT_DF_RETX] = r0;
+ [p1 + PDA_INIT_DF_DCPLB] = r1;
+ [p1 + PDA_INIT_DF_ICPLB] = r2;
+ [p1 + PDA_INIT_DF_SEQSTAT] = r3;
#endif
+ [p1 + PDA_INIT_RETX] = r4;
/* Initialize stack pointer */
sp.l = _init_thread_union + THREAD_SIZE;