IB/mthca: Allow the QP state transition RESET->RESET
RESET->RESET is an allowed QP state transition, so mthca should handle
it correctly, by just returning success without involving the firmware.
Signed-off-by: Dotan Barak <dotanb@mellanox.co.il>
Signed-off-by: Roland Dreier <rolandd@cisco.com>
diff --git a/drivers/infiniband/hw/mthca/mthca_qp.c b/drivers/infiniband/hw/mthca/mthca_qp.c
index 224c93d..71dc84b 100644
--- a/drivers/infiniband/hw/mthca/mthca_qp.c
+++ b/drivers/infiniband/hw/mthca/mthca_qp.c
@@ -573,6 +573,11 @@
goto out;
}
+ if (cur_state == new_state && cur_state == IB_QPS_RESET) {
+ err = 0;
+ goto out;
+ }
+
if ((attr_mask & IB_QP_PKEY_INDEX) &&
attr->pkey_index >= dev->limits.pkey_table_len) {
mthca_dbg(dev, "P_Key index (%u) too large. max is %d\n",