qlge: Fix out of sync hardware semaphore.
ql_clear_routing_entries() takes/gives it's own hardware semaphore since
it is called from more than one place. ql_route_initialize() should
make this call and THEN take it's own semaphore before doing it's work.
Signed-off-by: Ron Mercer <ron.mercer@qlogic.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/qlge/qlge_main.c b/drivers/net/qlge/qlge_main.c
index 7783c5d..32e4f57 100644
--- a/drivers/net/qlge/qlge_main.c
+++ b/drivers/net/qlge/qlge_main.c
@@ -3142,14 +3142,14 @@
{
int status = 0;
- status = ql_sem_spinlock(qdev, SEM_RT_IDX_MASK);
- if (status)
- return status;
-
/* Clear all the entries in the routing table. */
status = ql_clear_routing_entries(qdev);
if (status)
- goto exit;
+ return status;
+
+ status = ql_sem_spinlock(qdev, SEM_RT_IDX_MASK);
+ if (status)
+ return status;
status = ql_set_routing_reg(qdev, RT_IDX_ALL_ERR_SLOT, RT_IDX_ERR, 1);
if (status) {