Allow goldfish-setup to put the emulator in WiFi-only mode
The goldfish-setup service (essentially /system/etc/init.goldfish.sh)
executes the following commands when certain conditions are met:
setprop ro.radio.noril yes
stop ril-daemon
so as to stop the RIL daemon and emulate a WiFi-only device. Both would
fail, though, because goldfish-setup does not have the permissions to
set relevant properties.
This CL modifies the emulator's SELinux policy to grant the necessary
permissions. It is a step towards fixing the ril-daemon-keeps-getting-
killed-and-restarted problem with the new ("ranchu") emulator, which
does not support telephony emulation yet. (The other step is to have
init start goldfish-setup, which will be done in a seperate CL.)
Change-Id: Ice7e7898804b7353ac4a8c49d871b1b2571d7a5f
Signed-off-by: Yu Ning <yu.ning@intel.com>
diff --git a/target/board/generic/sepolicy/goldfish_setup.te b/target/board/generic/sepolicy/goldfish_setup.te
index c4fe9d6..3fb79e7 100644
--- a/target/board/generic/sepolicy/goldfish_setup.te
+++ b/target/board/generic/sepolicy/goldfish_setup.te
@@ -15,3 +15,10 @@
# Set net.eth0.dns*, debug.sf.nobootanimation
set_prop(goldfish_setup, system_prop)
set_prop(goldfish_setup, debug_prop)
+
+# Set ro.radio.noril
+set_prop(goldfish_setup, radio_noril_prop)
+
+# Stop ril-daemon service (by setting ctl.stop to ril-daemon, which
+# transforms to a permission check on ctl.ril-daemon).
+set_prop(goldfish_setup, ctl_rildaemon_prop)