Changes to support execution in AArch32 state for JUNO
Following steps are required to boot JUNO in AArch32 state:
1> BL1, in AArch64 state, loads BL2.
2> BL2, in AArch64 state, initializes DDR.
Loads SP_MIN & BL33 (AArch32 executable)images.
Calls RUN_IMAGE SMC to go back to BL1.
3> BL1 writes AArch32 executable opcodes, to load and branch
at the entrypoint address of SP_MIN, at HI-VECTOR address and
then request for warm reset in AArch32 state using RMR_EL3.
This patch makes following changes to facilitate above steps:
* Added assembly function to carry out step 3 above.
* Added region in TZC that enables Secure access to the
HI-VECTOR(0xFFFF0000) address space.
* AArch32 image descriptor is used, in BL2, to load
SP_MIN and BL33 AArch32 executable images.
A new flag `JUNO_AARCH32_EL3_RUNTIME` is introduced that
controls above changes. By default this flag is disabled.
NOTE: BL1 and BL2 are not supported in AArch32 state for JUNO.
Change-Id: I091d56a0e6d36663e6d9d2bb53c92c672195d1ec
Signed-off-by: Yatharth Kochar <yatharth.kochar@arm.com>
Signed-off-by: dp-arm <dimitris.papastamos@arm.com>
diff --git a/include/plat/arm/common/plat_arm.h b/include/plat/arm/common/plat_arm.h
index b24af78..d68a3e3 100644
--- a/include/plat/arm/common/plat_arm.h
+++ b/include/plat/arm/common/plat_arm.h
@@ -157,6 +157,7 @@
void arm_bl2_plat_arch_setup(void);
uint32_t arm_get_spsr_for_bl32_entry(void);
uint32_t arm_get_spsr_for_bl33_entry(void);
+int arm_bl2_handle_post_image_load(unsigned int image_id);
/* BL2U utility functions */
void arm_bl2u_early_platform_setup(struct meminfo *mem_layout,