Improve vertical metrics calculation (Savannah bug #27364).
The calculation of `vertBearingX' is not defined in the OTF font
spec so FreeType does a `best effort' attempt. However, this value
is defined in the PDF and PostScript specs, and that algorithm is
better than the one FreeType currently uses:
FreeType: Use the middle of the bounding box as the X coordinate
of the vertical origin.
Adobe PDF spec: Use the middle of the horizontal advance vector as
the X coordinate of the vertical origin.
FreeType's algorithm goes wrong if you have a really small glyph
(like the full-width, circle-like dot at the end of the sentence, as
used in CJK scripts) with large bearings. With the FreeType
algorithm this dot gets centered on the baseline; with the PDF
algorithm it gets the correct location (in the top right). Note
that this is a serious issue, it's like printing the dot at the end
of a Roman sentence at the center of the textline instead of on the
baseline like it should. So i believe the PDF spec's algorithm
should be used in FreeType as well.
The `vertBearingY' value for such small glyphs is also very strange
if no `vmtx' information is present, since the height of the bbox is
not representable for the height of the glyph visually (the
whitespace up to the baseline is part of the glyph). The fix also
includes some code for a better estimate of `vertBearingY'.
* src/base/ftobjs.c (ft_synthesize_vertical_metrics): `vertBearingX'
is now calculated as described by the Adobe PDF Spec. Estimate for
`vertBearingY' now works better for small glyphs completely above or
below the baseline into account.
* src/cff/cffgload.c (cff_slot_load): `vertBearingX' is now
calculated as described by the Adobe PDF Spec. Vertical metrics
information was always ignored when FT_CONFIG_OPTION_OLD_INTERNALS
was not defined.
* src/truetype/ttgload.c (compute_glyph_metrics): `vertBearingX' is
now calculated as described by the Adobe PDF Spec.
4 files changed