tc/actions: introduce support for jump action
Sample use case:
... add ingress qdisc
sudo $TC qdisc add dev $ETH ingress
... if we exceed rate of 1kbps (burst of 90K), do an absolute jump of 2 actions
sudo $TC actions add action police rate 1kbit burst 90k conform-exceed jump 2 / pipe
sudo $TC -s actions ls action police
action order 0: police 0x4 rate 1Kbit burst 23440b mtu 2Kb action jump 2/pipe overhead 0b
ref 1 bind 0 installed 41 sec used 41 sec
Action statistics:
Sent 0 bytes 0 pkt (dropped 0, overlimits 0 requeues 0)
backlog 0b 0p requeues 0
... lets add a couple of marks so we can use them to mark exceed/not exceed
sudo $TC actions add action skbedit mark 11 ok index 11
sudo $TC actions add action skbedit mark 12 ok index 12
... if we dont exceed our rate we get a mark of 11, else mark of 12
sudo $TC filter add dev $ETH parent ffff: protocol ip prio 8 u32 \
match ip dst 127.0.0.8/32 flowid 1:10 \
action police index 4 \
action skbedit index 11 \
action skbedit index 12
Ok, lets keep this thing a little busy..
sudo ping -f -c 10000 127.0.0.8
... now lets see the filters..
sudo $TC -s filter ls dev $ETH parent ffff: protocol ip
filter pref 8 u32 chain 0
filter pref 8 u32 chain 0 fh 800: ht divisor 1
filter pref 8 u32 chain 0 fh 800::800 order 2048 key ht 800 bkt 0 flowid 1:10 not_in_hw (rule hit 20000 success 10000)
match 7f000008/ffffffff at 16 (success 10000 )
action order 1: police 0x4 rate 1Kbit burst 23440b mtu 2Kb action jump 2/pipe overhead 0b
ref 2 bind 1 installed 198 sec used 2 sec
Action statistics:
Sent 840000 bytes 10000 pkt (dropped 0, overlimits 9721 requeues 0)
backlog 0b 0p requeues 0
action order 2: skbedit mark 11 pass
index 11 ref 2 bind 1 installed 127 sec used 2 sec
Action statistics:
Sent 23436 bytes 279 pkt (dropped 0, overlimits 0 requeues 0)
backlog 0b 0p requeues 0
action order 3: skbedit mark 12 pass
index 12 ref 2 bind 1 installed 127 sec used 2 sec
Action statistics:
Sent 816564 bytes 9721 pkt (dropped 0, overlimits 0 requeues 0)
backlog 0b 0p requeues 0
As can be seen 97.21% of the packets were marked as exceeding the allocated
rate; you could do something clever with the skb mark after this.
Signed-off-by: Jamal Hadi Salim <jhs@mojatatu.com>
Signed-off-by: Stephen Hemminger <stephen@networkplumber.org>
2 files changed