update nl80211.h
diff --git a/nl80211.h b/nl80211.h
index 216b1d8..109cac5 100644
--- a/nl80211.h
+++ b/nl80211.h
@@ -420,6 +420,14 @@
* new station with the AUTHENTICATED flag unset and maybe change it later
* depending on the authentication result.
*
+ * @NL80211_CMD_GET_WOWLAN: get Wake-on-Wireless-LAN (WoWLAN) settings.
+ * @NL80211_CMD_SET_WOWLAN: set Wake-on-Wireless-LAN (WoWLAN) settings.
+ * Since wireless is more complex than wired ethernet, it supports
+ * various triggers. These triggers can be configured through this
+ * command with the %NL80211_ATTR_WOWLAN_TRIGGERS attribute. For
+ * more background information, see
+ * http://wireless.kernel.org/en/users/Documentation/WoWLAN.
+ *
* @NL80211_CMD_MAX: highest used command number
* @__NL80211_CMD_AFTER_LAST: internal use
*/
@@ -534,6 +542,9 @@
NL80211_CMD_NEW_PEER_CANDIDATE,
+ NL80211_CMD_GET_WOWLAN,
+ NL80211_CMD_SET_WOWLAN,
+
/* add new commands above here */
/* used to define NL80211_CMD_MAX below */
@@ -903,6 +914,13 @@
* allows auth frames in a mesh to be passed to userspace for processing via
* the @NL80211_MESH_SETUP_USERSPACE_AUTH flag.
*
+ * @NL80211_ATTR_WOWLAN_SUPPORTED: indicates, as part of the wiphy capabilities,
+ * the supported WoWLAN triggers
+ * @NL80211_ATTR_WOWLAN_TRIGGERS: used by %NL80211_CMD_SET_WOWLAN to
+ * indicate which WoW triggers should be enabled. This is also
+ * used by %NL80211_CMD_GET_WOWLAN to get the currently enabled WoWLAN
+ * triggers.
+ *
* @NL80211_ATTR_MAX: highest attribute number currently defined
* @__NL80211_ATTR_AFTER_LAST: internal use
*/
@@ -1092,6 +1110,9 @@
NL80211_ATTR_SUPPORT_MESH_AUTH,
+ NL80211_ATTR_WOWLAN_TRIGGERS,
+ NL80211_ATTR_WOWLAN_TRIGGERS_SUPPORTED,
+
/* add attributes here, update the policy in nl80211.c */
__NL80211_ATTR_AFTER_LAST,
@@ -2061,4 +2082,82 @@
NL80211_TX_POWER_FIXED,
};
+/**
+ * enum nl80211_wowlan_packet_pattern_attr - WoWLAN packet pattern attribute
+ * @__NL80211_WOWLAN_PKTPAT_INVALID: invalid number for nested attribute
+ * @NL80211_WOWLAN_PKTPAT_PATTERN: the pattern, values where the mask has
+ * a zero bit are ignored
+ * @NL80211_WOWLAN_PKTPAT_MASK: pattern mask, must be long enough to have
+ * a bit for each byte in the pattern. The lowest-order bit corresponds
+ * to the first byte of the pattern, but the bytes of the pattern are
+ * in a little-endian-like format, i.e. the 9th byte of the pattern
+ * corresponds to the lowest-order bit in the second byte of the mask.
+ * For example: The match 00:xx:00:00:xx:00:00:00:00:xx:xx:xx (where
+ * xx indicates "don't care") would be represented by a pattern of
+ * twelve zero bytes, and a mask of "0xed,0x07".
+ * Note that the pattern matching is done as though frames were not
+ * 802.11 frames but 802.3 frames, i.e. the frame is fully unpacked
+ * first (including SNAP header unpacking) and then matched.
+ * @NUM_NL80211_WOWLAN_PKTPAT: number of attributes
+ * @MAX_NL80211_WOWLAN_PKTPAT: max attribute number
+ */
+enum nl80211_wowlan_packet_pattern_attr {
+ __NL80211_WOWLAN_PKTPAT_INVALID,
+ NL80211_WOWLAN_PKTPAT_MASK,
+ NL80211_WOWLAN_PKTPAT_PATTERN,
+
+ NUM_NL80211_WOWLAN_PKTPAT,
+ MAX_NL80211_WOWLAN_PKTPAT = NUM_NL80211_WOWLAN_PKTPAT - 1,
+};
+
+/**
+ * struct nl80211_wowlan_pattern_support - pattern support information
+ * @max_patterns: maximum number of patterns supported
+ * @min_pattern_len: minimum length of each pattern
+ * @max_pattern_len: maximum length of each pattern
+ *
+ * This struct is carried in %NL80211_WOWLAN_TRIG_PKT_PATTERN when
+ * that is part of %NL80211_ATTR_WOWLAN_TRIGGERS_SUPPORTED in the
+ * capability information given by the kernel to userspace.
+ */
+struct nl80211_wowlan_pattern_support {
+ __u32 max_patterns;
+ __u32 min_pattern_len;
+ __u32 max_pattern_len;
+} __attribute__((packed));
+
+/**
+ * enum nl80211_wowlan_triggers - WoWLAN trigger definitions
+ * @__NL80211_WOWLAN_TRIG_INVALID: invalid number for nested attributes
+ * @NL80211_WOWLAN_TRIG_ANY: wake up on any activity, do not really put
+ * the chip into a special state -- works best with chips that have
+ * support for low-power operation already (flag)
+ * @NL80211_WOWLAN_TRIG_DISCONNECT: wake up on disconnect, the way disconnect
+ * is detected is implementation-specific (flag)
+ * @NL80211_WOWLAN_TRIG_MAGIC_PKT: wake up on magic packet (6x 0xff, followed
+ * by 16 repetitions of MAC addr, anywhere in payload) (flag)
+ * @NL80211_WOWLAN_TRIG_PKT_PATTERN: wake up on the specified packet patterns
+ * which are passed in an array of nested attributes, each nested attribute
+ * defining a with attributes from &struct nl80211_wowlan_trig_pkt_pattern.
+ * Each pattern defines a wakeup packet. The matching is done on the MSDU,
+ * i.e. as though the packet was an 802.3 packet, so the pattern matching
+ * is done after the packet is converted to the MSDU.
+ *
+ * In %NL80211_ATTR_WOWLAN_TRIGGERS_SUPPORTED, it is a binary attribute
+ * carrying a &struct nl80211_wowlan_pattern_support.
+ * @NUM_NL80211_WOWLAN_TRIG: number of wake on wireless triggers
+ * @MAX_NL80211_WOWLAN_TRIG: highest wowlan trigger attribute number
+ */
+enum nl80211_wowlan_triggers {
+ __NL80211_WOWLAN_TRIG_INVALID,
+ NL80211_WOWLAN_TRIG_ANY,
+ NL80211_WOWLAN_TRIG_DISCONNECT,
+ NL80211_WOWLAN_TRIG_MAGIC_PKT,
+ NL80211_WOWLAN_TRIG_PKT_PATTERN,
+
+ /* keep last */
+ NUM_NL80211_WOWLAN_TRIG,
+ MAX_NL80211_WOWLAN_TRIG = NUM_NL80211_WOWLAN_TRIG - 1
+};
+
#endif /* __LINUX_NL80211_H */