$Id: INSTALL,v 1.17 2004/03/01 22:16:02 robbiew Exp $

Quick Start
-----------

1> tar xzf ltp-XXXXXXXX.tar.gz
2> cd ltp
3> make
4> make install
5> ./runalltests.sh

*NOTE: The LTP assumes the existence of the nobody, bin, and daemon users and
their groups.  If these IDs do not exist, certain tests will fail. The users
and groups IDs should be the same, i.e. if user "nobody" is 99, then it's
group should also be "99". The names of the groups are irrelevant.


Detailed Installation
---------------------

Beyond the "Quick Start" instructions, there are only a few other things
that should be done.  The Linux Test Project build process uses a
minimalist approach.  There is a lot of room for improvement and
contributions are welcome.

1. Log in as root.

2. Untar the ltp tarball into a spare directory.  There is not a
   standard location for it yet.  We put it in our home directory
   while we're working on it.

3. Run "make" to build everything.
   *NOTE: Some of the Makefiles (example: pan/Makefile) require the lex (or
   flex) package to be installed.

4. You can run all of the tests sequentially by using the example test
   script runalltests.sh.  The script is there just to get you started.
   See pan(1) for more information on the test driver we have provided.
   It is simple, but it can do a lot of stuff.

   NOTE: The diskio and network tests will NOT be run by the runalltests.sh
   script.  We chose to separate these tests because of their required setup
   overhead.

5. The disk i/o tests can be run by executing the diskio.sh script.  In order
   for these tests to successfully operate a writable high-density 3.5" floppy
   must be in the disk drive and a CD-ROM with more than 100Mb of data must be
   in the CD-ROM drive.  The corresponding tests will fail if either disk is
   missing.

6. The network tests are executed by running the networktests.sh script. The
   network tests require some configuration for them to work correctly:

     i) First, there MUST be another test machine setup to act as the server
	to these client side tests.  This machine MUST have the LTP installed
	in the same exact location, i.e. if the client has /root/ltp, then the
	server must have /root/ltp.  This is required because certain tests
	expect to find server files in certain locations.  Make sure to compile
	the LTP on this server machine also.

    ii) Second, the server must be setup to allow the client to connect using
		 the "r" commands, such as rsh.  This is done by simply creating/editing
		 the ".rhosts" file under /root.  Place the hostname of the client
		 machine in this file to allow root to remotely connect without the use
		 of a password.

   iii) Next, certain services must be activated in order for certain tests to
	execute.  The following services are activated via inetd/xinetd:
		rlogind
		ftpd
		telnetd
		echo (stream)
		fingerd
		rshd
		 Also, because certain RPC programs are tested, the "portmapper" daemon
		 MUST be started, as well as NFS server AND lock services.

    iv) Finally, before running the networktests.sh script, two variables must
		 be set within the script file.  The "RHOST" variable should be set to
		 the hostname of the server.  The "PASSWD" variable should be set to
		 root's password on the server machine.  This is necessary for tests
		 such as telnet01 and ftp01.

   You can now successfully execute the networktests.sh script.