Update Python version numbers from 1.6 to 2.0 where appropriate.
Make some references between the distutils documents hyperlinks using
the \citetitle markup.
diff --git a/Doc/inst/inst.tex b/Doc/inst/inst.tex
index c4e67af..e6baac2 100644
--- a/Doc/inst/inst.tex
+++ b/Doc/inst/inst.tex
@@ -48,7 +48,7 @@
In the past, there has been little support for adding third-party
modules to an existing Python installation. With the introduction of
-the Python Distribution Utilities (Distutils for short) in Python 1.6,
+the Python Distribution Utilities (Distutils for short) in Python 2.0,
this is starting to change. Not everything will change overnight,
though, so while this document concentrates on installing module
distributions that use the Distutils, we will also spend some time
@@ -62,7 +62,7 @@
brief forays into using Python's interactive mode to explore your
installation, but that's it. If you're looking for information on how
to distribute your own Python modules so that others may use them, see
-the ``Distributing Python Modules'' manual.
+the \citetitle[../dist/dist.html]{Distributing Python Modules} manual.
\subsection{Best case: trivial installation}
@@ -274,12 +274,12 @@
\begin{tableiv}{l|l|l|c}{textrm}%
{Platform}{Standard installation location}{Default value}{Notes}
\lineiv{Unix (pure)}
- {\filenq{\filevar{prefix}/lib/python1.6/site-packages}}
- {\filenq{/usr/local/lib/python1.6/site-packages}}
+ {\filenq{\filevar{prefix}/lib/python2.0/site-packages}}
+ {\filenq{/usr/local/lib/python2.0/site-packages}}
{(1)}
\lineiv{Unix (non-pure)}
- {\filenq{\filevar{exec-prefix}/lib/python1.6/site-packages}}
- {\filenq{/usr/local/lib/python1.6/site-packages}}
+ {\filenq{\filevar{exec-prefix}/lib/python2.0/site-packages}}
+ {\filenq{/usr/local/lib/python2.0/site-packages}}
{(1)}
\lineiv{Windows}
{\filenq{\filevar{prefix}}}
@@ -314,11 +314,12 @@
installation uses for \filevar{prefix} and \filevar{exec-prefix} by
running Python in interactive mode and typing a few simple commands.
Under Unix, just type \code{python} at the shell prompt; under Windows,
-run ``Python 1.6 (interpreter)'' \XXX{right?}; under Mac~OS, \XXX{???}.
-Once the interpreter is started, you type Python code at the \code{>>>}
-prompt. For example, on my Linux system, I type the three Python
-statements shown below, and get the output as shown, to find out my
-\filevar{prefix} and \filevar{exec-prefix}:
+run ``Python 2.0 (interpreter)'' \XXX{right?}; under Mac~OS, \XXX{???}.
+Once the interpreter is started, you type Python code at the
+\samp{>>> } prompt. For example, on my Linux system, I type the three
+Python statements shown below, and get the output as shown, to find
+out my \filevar{prefix} and \filevar{exec-prefix}:
+
\begin{verbatim}
Python 1.5.2 (#1, Apr 18 1999, 16:03:16) [GCC pgcc-2.91.60 19981201 (egcs-1.1.1 on linux2
Copyright 1991-1995 Stichting Mathematisch Centrum, Amsterdam