diff --git a/Doc/library/decimal.rst b/Doc/library/decimal.rst
index c564a57..9bbde66 100644
--- a/Doc/library/decimal.rst
+++ b/Doc/library/decimal.rst
@@ -890,7 +890,7 @@
    :const:`ROUND_HALF_EVEN`.  All flags are cleared.  No traps are enabled (so that
    exceptions are not raised during computations).
 
-   Because the trapped are disabled, this context is useful for applications that
+   Because the traps are disabled, this context is useful for applications that
    prefer to have result value of :const:`NaN` or :const:`Infinity` instead of
    raising exceptions.  This allows an application to complete a run in the
    presence of conditions that would otherwise halt the program.
@@ -1309,7 +1309,7 @@
 :const:`True`.  An attempt to compare two Decimals using any of the ``<``,
 ``<=``, ``>`` or ``>=`` operators will raise the :exc:`InvalidOperation` signal
 if either operand is a :const:`NaN`, and return :const:`False` if this signal is
-trapped.  Note that the General Decimal Arithmetic specification does not
+not trapped.  Note that the General Decimal Arithmetic specification does not
 specify the behavior of direct comparisons; these rules for comparisons
 involving a :const:`NaN` were taken from the IEEE 854 standard (see Table 3 in
 section 5.7).  To ensure strict standards-compliance, use the :meth:`compare`
diff --git a/Lib/decimal.py b/Lib/decimal.py
index 8034039..4f23d33 100644
--- a/Lib/decimal.py
+++ b/Lib/decimal.py
@@ -801,7 +801,7 @@
     #   != comparisons involving a NaN always return True
     #   <, >, <= and >= comparisons involving a (quiet or signaling)
     #      NaN signal InvalidOperation, and return False if the
-    #      InvalidOperation is trapped.
+    #      InvalidOperation is not trapped.
     #
     # This behavior is designed to conform as closely as possible to
     # that specified by IEEE 754.