cmd_bootm.c: Only pass BOOTM_STATE_OS_CMDLINE on PowerPC/MIPS
In 5c427e4 we pass BOOTM_STATE_OS_CMDLINE as part of the bootm states to
run, on all arches. However, this is only valid / useful on PowerPC and
MIPS, and causes a problem on ARM where we specifically do not use it.
Rather than make this state fake pass like we do for GO on some arches
(which need updating to use the GO state), we should just not pass
CMDLINE except when it may be used, like before.
Tested-by: Dan Murphy <dmurphy@ti.com>
Signed-off-by: Tom Rini <trini@ti.com>
diff --git a/common/cmd_bootm.c b/common/cmd_bootm.c
index 349f165..166b901 100644
--- a/common/cmd_bootm.c
+++ b/common/cmd_bootm.c
@@ -800,7 +800,10 @@
return do_bootm_states(cmdtp, flag, argc, argv, BOOTM_STATE_START |
BOOTM_STATE_FINDOS | BOOTM_STATE_FINDOTHER |
- BOOTM_STATE_LOADOS | BOOTM_STATE_OS_CMDLINE |
+ BOOTM_STATE_LOADOS |
+#if defined(CONFIG_PPC) || defined(CONFIG_MIPS)
+ BOOTM_STATE_OS_CMDLINE |
+#endif
BOOTM_STATE_OS_PREP | BOOTM_STATE_OS_FAKE_GO |
BOOTM_STATE_OS_GO, &images, 1);
}