microblaze: Read information about RAM from DT
Do not setup ram start/size in board file. Read it from DT instead.
Signed-off-by: Michal Simek <michal.simek@xilinx.com>
diff --git a/include/configs/microblaze-generic.h b/include/configs/microblaze-generic.h
index cf7deea..9d14192 100644
--- a/include/configs/microblaze-generic.h
+++ b/include/configs/microblaze-generic.h
@@ -68,13 +68,6 @@
# endif
#endif
-#if !defined(CONFIG_OF_CONTROL) || \
- (defined(CONFIG_SPL_BUILD) && !defined(CONFIG_SPL_OF_CONTROL))
-/* ddr sdram - main memory */
-# define CONFIG_SYS_SDRAM_BASE XILINX_RAM_START
-# define CONFIG_SYS_SDRAM_SIZE XILINX_RAM_SIZE
-#endif
-
#define CONFIG_SYS_MALLOC_LEN 0xC0000
/* Stack location before relocation */
@@ -259,7 +252,7 @@
#define CONFIG_SYS_MAXARGS 15
#define CONFIG_SYS_LONGHELP
/* default load address */
-#define CONFIG_SYS_LOAD_ADDR XILINX_RAM_START
+#define CONFIG_SYS_LOAD_ADDR 0
#define CONFIG_BOOTDELAY -1 /* -1 disables auto-boot */
#define CONFIG_BOOTARGS "root=romfs"