Add common (with Linux) MTD partition scheme and "mtdparts" command
Old, obsolete and duplicated code was cleaned up and replace by the
new partitioning method. There are two possible approaches now:
* define a single, static partition
* use mtdparts command line option and dynamic partitioning
Default is static partitioning.
diff --git a/include/configs/DB64360.h b/include/configs/DB64360.h
index d6ce8a8..e2b4b1d 100644
--- a/include/configs/DB64360.h
+++ b/include/configs/DB64360.h
@@ -88,8 +88,6 @@
#ifndef __CONFIG_H
#define __CONFIG_H
-#include <asm/processor.h>
-
/* This define must be before the core.h include */
#define CONFIG_DB64360 1 /* this is an DB64360 board */
@@ -219,10 +217,27 @@
#define CONFIG_BOOTP_MASK (CONFIG_BOOTP_DEFAULT | \
CONFIG_BOOTP_BOOTFILESIZE)
+/*
+ * JFFS2 partitions
+ *
+ */
+/* No command line, one static partition, whole device */
+#undef CONFIG_JFFS2_CMDLINE
+#define CONFIG_JFFS2_DEV "nor1"
+#define CONFIG_JFFS2_PART_SIZE 0xFFFFFFFF
+#define CONFIG_JFFS2_PART_OFFSET 0x00000000
-/* Flash banks JFFS2 should use */
-#define CFG_JFFS2_FIRST_BANK 1
-#define CFG_JFFS2_NUM_BANKS 1
+/* mtdparts command line support */
+
+/* Use first bank for JFFS2, second bank contains U-Boot.
+ *
+ * Note: fake mtd_id's used, no linux mtd map file.
+ */
+/*
+#define CONFIG_JFFS2_CMDLINE
+#define MTDIDS_DEFAULT "nor1=db64360-1"
+#define MTDPARTS_DEFAULT "mtdparts=db64360-1:-(jffs2)"
+*/
#define CONFIG_COMMANDS (CONFIG_CMD_DFL \
| CFG_CMD_ASKENV \