powerpc/83xx: configure CONFIG_POST for kmcoge5ne
kmcoge5ne starts the post tests if the testpin on
the board was enabled. Currently it does simply a memory
test.
Signed-off-by: Thomas Herzmann <thomas.herzmann@keymile.com>
Signed-off-by: Holger Brunck <holger.brunck@keymile.com>
Signed-off-by: Kim Phillips <kim.phillips@freescale.com>
diff --git a/include/configs/km8360.h b/include/configs/km8360.h
index 230b054..7631ab6 100644
--- a/include/configs/km8360.h
+++ b/include/configs/km8360.h
@@ -266,6 +266,14 @@
BATU_BL_256M |\
BATU_VS |\
BATU_VP)
+/* enable POST tests */
+#define CONFIG_POST (CONFIG_SYS_POST_MEMORY|CONFIG_SYS_POST_MEM_REGIONS)
+#define CONFIG_POST_EXTERNAL_WORD_FUNCS /* use own functions, not generic */
+#define CPM_POST_WORD_ADDR CONFIG_SYS_MEMTEST_END
+#define CONFIG_TESTPIN_REG gprt3 /* for kmcoge5ne */
+#define CONFIG_TESTPIN_MASK 0x20 /* for kmcoge5ne */
+#define CONFIG_CMD_DIAG /* so that testpin is inquired for POST test */
+
#else
#define CONFIG_SYS_IBAT6L (0)
#define CONFIG_SYS_IBAT6U (0)