ARM: zynq: Added USB host support for zynq boards
Added configs to support USB host for zynq boards.
Also added a command usbboot to boot from usb.
Signed-off-by: Siva Durga Prasad Paladugu <sivadur@xilinx.com>
Signed-off-by: Michal Simek <michal.simek@xilinx.com>
diff --git a/include/configs/zynq-common.h b/include/configs/zynq-common.h
index 8ee78e4..bcc476e 100644
--- a/include/configs/zynq-common.h
+++ b/include/configs/zynq-common.h
@@ -89,6 +89,18 @@
# define CONFIG_DOS_PARTITION
#endif
+#ifdef CONFIG_ZYNQ_USB
+# define CONFIG_USB_EHCI
+# define CONFIG_CMD_USB
+# define CONFIG_USB_STORAGE
+# define CONFIG_SUPPORT_VFAT
+# define CONFIG_USB_EHCI_ZYNQ
+# define CONFIG_USB_ULPI_VIEWPORT
+# define CONFIG_USB_ULPI
+# define CONFIG_EHCI_IS_TDI
+# define CONFIG_USB_MAX_CONTROLLER_COUNT 2
+#endif
+
#define CONFIG_SYS_I2C_ZYNQ
/* I2C */
#if defined(CONFIG_SYS_I2C_ZYNQ)
@@ -150,7 +162,13 @@
"bootm ${load_addr}\0" \
"jtagboot=echo TFTPing FIT to RAM... && " \
"tftpboot ${load_addr} ${fit_image} && " \
- "bootm ${load_addr}\0"
+ "bootm ${load_addr}\0" \
+ "usbboot=if usb start; then " \
+ "echo Copying FIT from USB to RAM... && " \
+ "fatload usb 0 ${load_addr} ${fit_image} && " \
+ "bootm ${load_addr}\0" \
+ "fi\0"
+
#define CONFIG_BOOTCOMMAND "run $modeboot"
#define CONFIG_BOOTDELAY 3 /* -1 to Disable autoboot */
#define CONFIG_SYS_LOAD_ADDR 0 /* default? */