SECURE_BOOT : enable esbc_validate command for powerpc and arm platforms.
esbc_validate command uses various IP Blocks: Security Monitor, CAAM block
and SFP registers. Hence the respective CONFIG's are enabled.
Apart from these CONFIG_SHA_PROG_HW_ACCEL and CONFIG_RSA are also enabled.
Signed-off-by: Gaurav Rana <gaurav.rana@freescale.com>
Reviewed-by: York Sun <yorksun@freescale.com>
diff --git a/arch/powerpc/include/asm/fsl_secure_boot.h b/arch/powerpc/include/asm/fsl_secure_boot.h
index b4c0c99..49f6814 100644
--- a/arch/powerpc/include/asm/fsl_secure_boot.h
+++ b/arch/powerpc/include/asm/fsl_secure_boot.h
@@ -6,6 +6,19 @@
#ifndef __FSL_SECURE_BOOT_H
#define __FSL_SECURE_BOOT_H
+#include <asm/config_mpc85xx.h>
+
+#ifdef CONFIG_SECURE_BOOT
+#define CONFIG_CMD_ESBC_VALIDATE
+#define CONFIG_FSL_SEC_MON
+#define CONFIG_SHA_PROG_HW_ACCEL
+#define CONFIG_DM
+#define CONFIG_RSA
+#define CONFIG_RSA_FREESCALE_EXP
+#ifndef CONFIG_FSL_CAAM
+#define CONFIG_FSL_CAAM
+#endif
+#endif
#ifdef CONFIG_SECURE_BOOT
#if defined(CONFIG_FSL_CORENET)
@@ -28,9 +41,31 @@
defined(CONFIG_PPC_T1023) || \
defined(CONFIG_PPC_T1024)
#define CONFIG_SYS_CPC_REINIT_F
+#define CONFIG_KEY_REVOCATION
#undef CONFIG_SYS_INIT_L3_ADDR
#define CONFIG_SYS_INIT_L3_ADDR 0xbff00000
#endif
+#if defined(CONFIG_C29XPCIE)
+#define CONFIG_KEY_REVOCATION
+#endif
+
+#if defined(CONFIG_PPC_P3041) || \
+ defined(CONFIG_PPC_P4080) || \
+ defined(CONFIG_PPC_P5020) || \
+ defined(CONFIG_PPC_P5040) || \
+ defined(CONFIG_PPC_P2041)
+ #define CONFIG_FSL_TRUST_ARCH_v1
+#endif
+
+#if defined(CONFIG_FSL_CORENET)
+/* The key used for verification of next level images
+ * is picked up from an Extension Table which has
+ * been verified by the ISBC (Internal Secure boot Code)
+ * in boot ROM of the SoC
+ */
+#define CONFIG_FSL_ISBC_KEY_EXT
+#endif
+
#endif
#endif