powerpc/t1023rdb: add support for T1023RDB RevC
Add support for NOR flash and GPIO/I2C switch control on RevC.
- NOR support
- bank0/bank4 switch
- SD/eMMC switch
- board version
Signed-off-by: Shengzhou Liu <Shengzhou.Liu@freescale.com>
Reviewed-by: York Sun <yorksun@freescale.com>
diff --git a/include/configs/T102xRDB.h b/include/configs/T102xRDB.h
index b67836c..bde71fb 100644
--- a/include/configs/T102xRDB.h
+++ b/include/configs/T102xRDB.h
@@ -11,12 +11,6 @@
#ifndef __T1024RDB_H
#define __T1024RDB_H
-#if defined(CONFIG_T1023RDB)
-#ifdef CONFIG_SPL
-#define CONFIG_SYS_NO_FLASH
-#endif
-#endif
-
/* High Level Configuration Options */
#define CONFIG_SYS_GENERIC_BOARD
#define CONFIG_DISPLAY_BOARDINFO
@@ -320,7 +314,7 @@
#if defined(CONFIG_T1024RDB)
#define CONFIG_SYS_NOR_CSOR CSOR_NAND_TRHZ_80
#elif defined(CONFIG_T1023RDB)
-#define CONFIG_SYS_NOR_CSOR (CSOR_NOR_ADM_SHIFT(4) | \
+#define CONFIG_SYS_NOR_CSOR (CSOR_NOR_ADM_SHIFT(0) | \
CSOR_NAND_TRHZ_80 | CSOR_NOR_ADM_SHFT_MODE_EN)
#endif
#define CONFIG_SYS_NOR_FTIM0 (FTIM0_NOR_TACSE(0x4) | \
@@ -559,9 +553,8 @@
#define CONFIG_SYS_FSL_I2C_OFFSET 0x118000
#define CONFIG_SYS_FSL_I2C2_OFFSET 0x118100
-#define I2C_MUX_PCA_ADDR 0x77
-#define I2C_MUX_PCA_ADDR_PRI 0x77 /* Primary Mux*/
-
+#define I2C_PCA6408_BUS_NUM 1
+#define I2C_PCA6408_ADDR 0x20
/* I2C bus multiplexer */
#define I2C_MUX_CH_DEFAULT 0x8
@@ -759,8 +752,10 @@
#define CONFIG_SYS_DPAA_FMAN
+#ifdef CONFIG_T1024RDB
#define CONFIG_QE
#define CONFIG_U_QE
+#endif
/* Default address of microcode for the Linux FMan driver */
#if defined(CONFIG_SPIFLASH)
/*