prima: Send max tx power per band via SME queue
Currently for set max tx power per band, driver doesn't check for
current power state and directly passes that to firmware. This can
lead to crash if device is in IMPS state as firmware tries to
access phy register in chip power down state. Fix this by sending
max tx power per band request via SME queue.
Change-Id: Ic09744e0caef73ac450f5016076afa49d397bc33
CRs-Fixed: 1077944
diff --git a/CORE/SME/inc/sme_Api.h b/CORE/SME/inc/sme_Api.h
index 842f998..eb65b7f 100644
--- a/CORE/SME/inc/sme_Api.h
+++ b/CORE/SME/inc/sme_Api.h
@@ -2743,15 +2743,19 @@
eHalStatus sme_SetMaxTxPower(tHalHandle hHal, tSirMacAddr pBssid,
tSirMacAddr pSelfMacAddress, v_S7_t dB);
-/* ---------------------------------------------------------------------------
- \fn sme_SetMaxTxPowerPerBand
- \brief Used to set the Maximum Transmit Power for
- specific band dynamically. Note: this setting will not persist over reboots
- \param band
- \param power to set in dB
- \- return eHalStatus
- -------------------------------------------------------------------------*/
-eHalStatus sme_SetMaxTxPowerPerBand(eCsrBand band, v_S7_t db);
+/**
+ * sme_SetMaxTxPowerPerBand() - Set the Maximum Transmit Power
+ * specific to band dynamically
+ * @band: Band for which power needs to be applied
+ * @dB: power to set in dB
+ * @hal: HAL handle
+ *
+ * Set the maximum transmit power dynamically per band
+ *
+ * Return: eHalStatus
+ */
+eHalStatus sme_SetMaxTxPowerPerBand(eCsrBand band, v_S7_t dB,
+ tHalHandle hal);
/* ---------------------------------------------------------------------------