qcacld-3.0: Remove legacy call to cds_is_target_ready
When wma_create_peer is called, driver checks for
cds_is_target_ready and the macro CDS_DRIVER_STATE_FW_READY is
unset during the wlan_hdd_pld_uevent. This results in race
condition where the wma_peer_create fails due to
cds_is_target_ready() failure and wma_vdev_delete is sent from
wma_vdev_attach. In wmi_stopinprogress is set when firmware is
down. But this is set only after a small delay and the vdev
commands reach the fw, which results in a race condition.
Remove the cds_is_target_ready() call from wma_create_peer.
Place the call to wma_wmi_stop() to set the wmi_stopinprogress
flag immediately after the wlan_hdd_pld_uevent is received.
Change-Id: Iea53931771afd93ffaeabf704bbaffcf2460284f
CRs-Fixed: 2320538
3 files changed