Joe Fernandez | 7dfe7f8 | 2012-05-30 16:19:51 -0700 | [diff] [blame] | 1 | ASHIELD Board, v2.2 |
| 2 | 3/25/2011 |
| 3 | |
| 4 | Route board out on 0-mil perimeter in top silk. |
| 5 | |
| 6 | Standard .062" FR4, 1oz Cu, RoHS, HASL |
| 7 | |
| 8 | Board is 2 layers, plus unusual silk screen (see notes below) |
| 9 | |
| 10 | !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! |
| 11 | NOTE: VENDOR MARK AND TEST STAMP SHOULD BE PLACED WITHIN JOY1 RECTANGLE. |
| 12 | MARK AND STAMP MUST NOT BE VISIBLE ONCE BOARD IS ASSEMBLED. |
| 13 | !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! |
| 14 | |
| 15 | Other Notes: |
| 16 | |
| 17 | Board is WHITE SMOBC |
| 18 | |
| 19 | ashield_blk.plc BLACK primary (first applied) silk, component side |
| 20 | This is a base silk. Colored silks go on top of this one. |
| 21 | |
| 22 | ashield_blk.pls BLACK silk for bottom (solder) side of board |
| 23 | |
| 24 | ashield.drl Drill rack |
| 25 | ashield.drd Excellon drill file |
| 26 | |
| 27 | ashield.cmp Component side copper |
| 28 | ashield.stc Component side stop mask |
| 29 | |
| 30 | ashield.sol Solder side copper |
| 31 | ashield.sts Solder side stop mask |
| 32 | |
| 33 | All components on TOP side of board, EXCEPT for 6 single-row in-line headers |
| 34 | on left and right edges. There is 1 6-pin header and 5 8-pin headers. These |
| 35 | mount from the bottom, and are soldered from the top. |
| 36 | |
| 37 | Through-hole leads should be trimmed flush. |
| 38 | |