wl1271: Update memory mapping for firmware revision 6.1.0.0.241
Update the memory regions and memory mapping to support firmware revision
6.1.0.0.241.
Signed-off-by: Juuso Oikarinen <juuso.oikarinen@nokia.com>
Reviewed-by: Luciano Coelho <luciano.coelho@nokia.com>
Signed-off-by: Luciano Coelho <luciano.coelho@nokia.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/wl12xx/wl1271_spi.c b/drivers/net/wireless/wl12xx/wl1271_spi.c
index 504991a..367f2d3 100644
--- a/drivers/net/wireless/wl12xx/wl1271_spi.c
+++ b/drivers/net/wireless/wl12xx/wl1271_spi.c
@@ -30,17 +30,29 @@
#include "wl12xx_80211.h"
#include "wl1271_spi.h"
-static int wl1271_translate_reg_addr(struct wl1271 *wl, int addr)
+static int wl1271_translate_addr(struct wl1271 *wl, int addr)
{
- return addr - wl->physical_reg_addr + wl->virtual_reg_addr;
+ /*
+ * To translate, first check to which window of addresses the
+ * particular address belongs. Then subtract the starting address
+ * of that window from the address. Then, add offset of the
+ * translated region.
+ *
+ * The translated regions occur next to each other in physical device
+ * memory, so just add the sizes of the preceeding address regions to
+ * get the offset to the new region.
+ *
+ * Currently, only the two first regions are addressed, and the
+ * assumption is that all addresses will fall into either of those
+ * two.
+ */
+ if ((addr >= wl->part.reg.start) &&
+ (addr < wl->part.reg.start + wl->part.reg.size))
+ return addr - wl->part.reg.start + wl->part.mem.size;
+ else
+ return addr - wl->part.mem.start;
}
-static int wl1271_translate_mem_addr(struct wl1271 *wl, int addr)
-{
- return addr - wl->physical_mem_addr + wl->virtual_mem_addr;
-}
-
-
void wl1271_spi_reset(struct wl1271 *wl)
{
u8 *cmd;
@@ -123,123 +135,61 @@
/* Set the SPI partitions to access the chip addresses
*
- * There are two VIRTUAL (SPI) partitions (the memory partition and the
- * registers partition), which are mapped to two different areas of the
- * PHYSICAL (hardware) memory. This function also makes other checks to
- * ensure that the partitions are not overlapping. In the diagram below, the
- * memory partition comes before the register partition, but the opposite is
- * also supported.
+ * To simplify driver code, a fixed (virtual) memory map is defined for
+ * register and memory addresses. Because in the chipset, in different stages
+ * of operation, those addresses will move around, an address translation
+ * mechanism is required.
*
- * PHYSICAL address
+ * There are four partitions (three memory and one register partition),
+ * which are mapped to two different areas of the hardware memory.
+ *
+ * Virtual address
* space
*
* | |
- * ...+----+--> mem_start
- * VIRTUAL address ... | |
+ * ...+----+--> mem.start
+ * Physical address ... | |
* space ... | | [PART_0]
* ... | |
- * 0x00000000 <--+----+... ...+----+--> mem_start + mem_size
+ * 00000000 <--+----+... ...+----+--> mem.start + mem.size
* | | ... | |
* |MEM | ... | |
* | | ... | |
- * part_size <--+----+... | | {unused area)
+ * mem.size <--+----+... | | {unused area)
* | | ... | |
* |REG | ... | |
- * part_size | | ... | |
- * + <--+----+... ...+----+--> reg_start
- * reg_size ... | |
- * ... | | [PART_1]
- * ... | |
- * ...+----+--> reg_start + reg_size
+ * mem.size | | ... | |
+ * + <--+----+... ...+----+--> reg.start
+ * reg.size | | ... | |
+ * |MEM2| ... | | [PART_1]
+ * | | ... | |
+ * ...+----+--> reg.start + reg.size
* | |
*
*/
int wl1271_set_partition(struct wl1271 *wl,
- u32 mem_start, u32 mem_size,
- u32 reg_start, u32 reg_size)
+ struct wl1271_partition_set *p)
{
- struct wl1271_partition *partition;
- struct spi_transfer t;
- struct spi_message m;
- size_t len, cmd_len;
- u32 *cmd;
- int addr;
-
- cmd_len = sizeof(u32) + 2 * sizeof(struct wl1271_partition);
- cmd = kzalloc(cmd_len, GFP_KERNEL);
- if (!cmd)
- return -ENOMEM;
-
- spi_message_init(&m);
- memset(&t, 0, sizeof(t));
-
- partition = (struct wl1271_partition *) (cmd + 1);
- addr = HW_ACCESS_PART0_SIZE_ADDR;
- len = 2 * sizeof(struct wl1271_partition);
-
- *cmd |= WSPI_CMD_WRITE;
- *cmd |= (len << WSPI_CMD_BYTE_LENGTH_OFFSET) & WSPI_CMD_BYTE_LENGTH;
- *cmd |= addr & WSPI_CMD_BYTE_ADDR;
+ /* copy partition info */
+ memcpy(&wl->part, p, sizeof(*p));
wl1271_debug(DEBUG_SPI, "mem_start %08X mem_size %08X",
- mem_start, mem_size);
+ p->mem.start, p->mem.size);
wl1271_debug(DEBUG_SPI, "reg_start %08X reg_size %08X",
- reg_start, reg_size);
+ p->reg.start, p->reg.size);
+ wl1271_debug(DEBUG_SPI, "mem2_start %08X mem2_size %08X",
+ p->mem2.start, p->mem2.size);
+ wl1271_debug(DEBUG_SPI, "mem3_start %08X mem3_size %08X",
+ p->mem3.start, p->mem3.size);
- /* Make sure that the two partitions together don't exceed the
- * address range */
- if ((mem_size + reg_size) > HW_ACCESS_MEMORY_MAX_RANGE) {
- wl1271_debug(DEBUG_SPI, "Total size exceeds maximum virtual"
- " address range. Truncating partition[0].");
- mem_size = HW_ACCESS_MEMORY_MAX_RANGE - reg_size;
- wl1271_debug(DEBUG_SPI, "mem_start %08X mem_size %08X",
- mem_start, mem_size);
- wl1271_debug(DEBUG_SPI, "reg_start %08X reg_size %08X",
- reg_start, reg_size);
- }
-
- if ((mem_start < reg_start) &&
- ((mem_start + mem_size) > reg_start)) {
- /* Guarantee that the memory partition doesn't overlap the
- * registers partition */
- wl1271_debug(DEBUG_SPI, "End of partition[0] is "
- "overlapping partition[1]. Adjusted.");
- mem_size = reg_start - mem_start;
- wl1271_debug(DEBUG_SPI, "mem_start %08X mem_size %08X",
- mem_start, mem_size);
- wl1271_debug(DEBUG_SPI, "reg_start %08X reg_size %08X",
- reg_start, reg_size);
- } else if ((reg_start < mem_start) &&
- ((reg_start + reg_size) > mem_start)) {
- /* Guarantee that the register partition doesn't overlap the
- * memory partition */
- wl1271_debug(DEBUG_SPI, "End of partition[1] is"
- " overlapping partition[0]. Adjusted.");
- reg_size = mem_start - reg_start;
- wl1271_debug(DEBUG_SPI, "mem_start %08X mem_size %08X",
- mem_start, mem_size);
- wl1271_debug(DEBUG_SPI, "reg_start %08X reg_size %08X",
- reg_start, reg_size);
- }
-
- partition[0].start = mem_start;
- partition[0].size = mem_size;
- partition[1].start = reg_start;
- partition[1].size = reg_size;
-
- wl->physical_mem_addr = mem_start;
- wl->physical_reg_addr = reg_start;
-
- wl->virtual_mem_addr = 0;
- wl->virtual_reg_addr = mem_size;
-
- t.tx_buf = cmd;
- t.len = cmd_len;
- spi_message_add_tail(&t, &m);
-
- spi_sync(wl->spi, &m);
-
- kfree(cmd);
+ /* write partition info to the chipset */
+ wl1271_write32(wl, HW_PART0_START_ADDR, p->mem.start);
+ wl1271_write32(wl, HW_PART0_SIZE_ADDR, p->mem.size);
+ wl1271_write32(wl, HW_PART1_START_ADDR, p->reg.start);
+ wl1271_write32(wl, HW_PART1_SIZE_ADDR, p->reg.size);
+ wl1271_write32(wl, HW_PART2_START_ADDR, p->mem2.start);
+ wl1271_write32(wl, HW_PART2_SIZE_ADDR, p->mem2.size);
+ wl1271_write32(wl, HW_PART3_START_ADDR, p->mem3.start);
return 0;
}
@@ -391,7 +341,7 @@
{
int physical;
- physical = wl1271_translate_mem_addr(wl, addr);
+ physical = wl1271_translate_addr(wl, addr);
wl1271_spi_read(wl, physical, buf, len, false);
}
@@ -401,7 +351,7 @@
{
int physical;
- physical = wl1271_translate_mem_addr(wl, addr);
+ physical = wl1271_translate_addr(wl, addr);
wl1271_spi_write(wl, physical, buf, len, false);
}
@@ -411,7 +361,7 @@
{
int physical;
- physical = wl1271_translate_reg_addr(wl, addr);
+ physical = wl1271_translate_addr(wl, addr);
wl1271_spi_read(wl, physical, buf, len, fixed);
}
@@ -421,27 +371,27 @@
{
int physical;
- physical = wl1271_translate_reg_addr(wl, addr);
+ physical = wl1271_translate_addr(wl, addr);
wl1271_spi_write(wl, physical, buf, len, fixed);
}
u32 wl1271_mem_read32(struct wl1271 *wl, int addr)
{
- return wl1271_read32(wl, wl1271_translate_mem_addr(wl, addr));
+ return wl1271_read32(wl, wl1271_translate_addr(wl, addr));
}
void wl1271_mem_write32(struct wl1271 *wl, int addr, u32 val)
{
- wl1271_write32(wl, wl1271_translate_mem_addr(wl, addr), val);
+ wl1271_write32(wl, wl1271_translate_addr(wl, addr), val);
}
u32 wl1271_reg_read32(struct wl1271 *wl, int addr)
{
- return wl1271_read32(wl, wl1271_translate_reg_addr(wl, addr));
+ return wl1271_read32(wl, wl1271_translate_addr(wl, addr));
}
void wl1271_reg_write32(struct wl1271 *wl, int addr, u32 val)
{
- wl1271_write32(wl, wl1271_translate_reg_addr(wl, addr), val);
+ wl1271_write32(wl, wl1271_translate_addr(wl, addr), val);
}