| /* |
| * Copyright 2008 Cavium Networks |
| * |
| * This file is free software; you can redistribute it and/or modify |
| * it under the terms of the GNU General Public License, Version 2, as |
| * published by the Free Software Foundation. |
| */ |
| |
| #include <linux/platform_device.h> |
| #include <linux/atomic.h> |
| #include <mach/cns3xxx.h> |
| #include <mach/pm.h> |
| |
| static int cns3xxx_ehci_init(struct usb_hcd *hcd) |
| { |
| struct ehci_hcd *ehci = hcd_to_ehci(hcd); |
| int retval; |
| |
| /* |
| * EHCI and OHCI share the same clock and power, |
| * resetting twice would cause the 1st controller been reset. |
| * Therefore only do power up at the first up device, and |
| * power down at the last down device. |
| * |
| * Set USB AHB INCR length to 16 |
| */ |
| if (atomic_inc_return(&usb_pwr_ref) == 1) { |
| cns3xxx_pwr_power_up(1 << PM_PLL_HM_PD_CTRL_REG_OFFSET_PLL_USB); |
| cns3xxx_pwr_clk_en(1 << PM_CLK_GATE_REG_OFFSET_USB_HOST); |
| cns3xxx_pwr_soft_rst(1 << PM_SOFT_RST_REG_OFFST_USB_HOST); |
| __raw_writel((__raw_readl(MISC_CHIP_CONFIG_REG) | (0X2 << 24)), |
| MISC_CHIP_CONFIG_REG); |
| } |
| |
| ehci->caps = hcd->regs; |
| ehci->regs = hcd->regs |
| + HC_LENGTH(ehci_readl(ehci, &ehci->caps->hc_capbase)); |
| ehci->hcs_params = ehci_readl(ehci, &ehci->caps->hcs_params); |
| |
| hcd->has_tt = 0; |
| ehci_reset(ehci); |
| |
| retval = ehci_init(hcd); |
| if (retval) |
| return retval; |
| |
| ehci_port_power(ehci, 0); |
| |
| return retval; |
| } |
| |
| static const struct hc_driver cns3xxx_ehci_hc_driver = { |
| .description = hcd_name, |
| .product_desc = "CNS3XXX EHCI Host Controller", |
| .hcd_priv_size = sizeof(struct ehci_hcd), |
| .irq = ehci_irq, |
| .flags = HCD_MEMORY | HCD_USB2, |
| .reset = cns3xxx_ehci_init, |
| .start = ehci_run, |
| .stop = ehci_stop, |
| .shutdown = ehci_shutdown, |
| .urb_enqueue = ehci_urb_enqueue, |
| .urb_dequeue = ehci_urb_dequeue, |
| .endpoint_disable = ehci_endpoint_disable, |
| .endpoint_reset = ehci_endpoint_reset, |
| .get_frame_number = ehci_get_frame, |
| .hub_status_data = ehci_hub_status_data, |
| .hub_control = ehci_hub_control, |
| #ifdef CONFIG_PM |
| .bus_suspend = ehci_bus_suspend, |
| .bus_resume = ehci_bus_resume, |
| #endif |
| .relinquish_port = ehci_relinquish_port, |
| .port_handed_over = ehci_port_handed_over, |
| |
| .clear_tt_buffer_complete = ehci_clear_tt_buffer_complete, |
| }; |
| |
| static int cns3xxx_ehci_probe(struct platform_device *pdev) |
| { |
| struct device *dev = &pdev->dev; |
| struct usb_hcd *hcd; |
| const struct hc_driver *driver = &cns3xxx_ehci_hc_driver; |
| struct resource *res; |
| int irq; |
| int retval; |
| |
| if (usb_disabled()) |
| return -ENODEV; |
| |
| res = platform_get_resource(pdev, IORESOURCE_IRQ, 0); |
| if (!res) { |
| dev_err(dev, "Found HC with no IRQ.\n"); |
| return -ENODEV; |
| } |
| irq = res->start; |
| |
| hcd = usb_create_hcd(driver, &pdev->dev, dev_name(&pdev->dev)); |
| if (!hcd) |
| return -ENOMEM; |
| |
| res = platform_get_resource(pdev, IORESOURCE_MEM, 0); |
| if (!res) { |
| dev_err(dev, "Found HC with no register addr.\n"); |
| retval = -ENODEV; |
| goto err1; |
| } |
| |
| hcd->rsrc_start = res->start; |
| hcd->rsrc_len = res->end - res->start + 1; |
| |
| if (!request_mem_region(hcd->rsrc_start, hcd->rsrc_len, |
| driver->description)) { |
| dev_dbg(dev, "controller already in use\n"); |
| retval = -EBUSY; |
| goto err1; |
| } |
| |
| hcd->regs = ioremap(hcd->rsrc_start, hcd->rsrc_len); |
| if (hcd->regs == NULL) { |
| dev_dbg(dev, "error mapping memory\n"); |
| retval = -EFAULT; |
| goto err2; |
| } |
| |
| retval = usb_add_hcd(hcd, irq, IRQF_SHARED); |
| if (retval == 0) |
| return retval; |
| |
| iounmap(hcd->regs); |
| err2: |
| release_mem_region(hcd->rsrc_start, hcd->rsrc_len); |
| err1: |
| usb_put_hcd(hcd); |
| |
| return retval; |
| } |
| |
| static int cns3xxx_ehci_remove(struct platform_device *pdev) |
| { |
| struct usb_hcd *hcd = platform_get_drvdata(pdev); |
| |
| usb_remove_hcd(hcd); |
| iounmap(hcd->regs); |
| release_mem_region(hcd->rsrc_start, hcd->rsrc_len); |
| |
| /* |
| * EHCI and OHCI share the same clock and power, |
| * resetting twice would cause the 1st controller been reset. |
| * Therefore only do power up at the first up device, and |
| * power down at the last down device. |
| */ |
| if (atomic_dec_return(&usb_pwr_ref) == 0) |
| cns3xxx_pwr_clk_dis(1 << PM_CLK_GATE_REG_OFFSET_USB_HOST); |
| |
| usb_put_hcd(hcd); |
| |
| platform_set_drvdata(pdev, NULL); |
| |
| return 0; |
| } |
| |
| MODULE_ALIAS("platform:cns3xxx-ehci"); |
| |
| static struct platform_driver cns3xxx_ehci_driver = { |
| .probe = cns3xxx_ehci_probe, |
| .remove = cns3xxx_ehci_remove, |
| .driver = { |
| .name = "cns3xxx-ehci", |
| }, |
| }; |