blob: 6484a106701ca80e94db4c0bbf6f4b45456ffe75 [file] [log] [blame]
/* Copyright (c) 2012-2015, 2017, The Linux Foundation. All rights reserved.
* Redistribution and use in source and binary forms, with or without
* modification, are permitted provided that the following conditions are
* met:
* * Redistributions of source code must retain the above copyright
* notice, this list of conditions and the following disclaimer.
* * Redistributions in binary form must reproduce the above
* copyright notice, this list of conditions and the following
* disclaimer in the documentation and/or other materials provided
* with the distribution.
* * Neither the name of The Linux Foundation, nor the names of its
* contributors may be used to endorse or promote products derived
* from this software without specific prior written permission.
*
* THIS SOFTWARE IS PROVIDED "AS IS" AND ANY EXPRESS OR IMPLIED
* WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF
* MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE AND NON-INFRINGEMENT
* ARE DISCLAIMED. IN NO EVENT SHALL THE COPYRIGHT OWNER OR CONTRIBUTORS
* BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR
* CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF
* SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR
* BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY,
* WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE
* OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN
* IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
*/
#ifndef _PM8x41_HW_H_
#define _PM8x41_HW_H_
#include <stdint.h>
#include <sys/types.h>
/* SMBB Registers */
#define SMBB_MISC_BOOT_DONE 0x1642
/* SMBB bit values */
#define BOOT_DONE_BIT 7
#define REVID_REVISION4 0x103
#define REVID_REV_ID_SPARE_0 0x160
/* LPG Registers */
#define LPG_SLAVE_ID 0x10000 /* slave_id == 1 */
#define LPG_PERIPHERAL_BASE (0x0B100 | LPG_SLAVE_ID)
/* Peripheral base address for LPG channel */
#define LPG_N_PERIPHERAL_BASE(x) (LPG_PERIPHERAL_BASE + ((x) - 1) * 0x100)
/* GPIO Registers */
#define GPIO_PERIPHERAL_BASE 0xC000
/* Peripheral base address for GPIO_X */
#define GPIO_N_PERIPHERAL_BASE(x) (GPIO_PERIPHERAL_BASE + ((x) - 1) * 0x100)
/* Register offsets within GPIO */
#define GPIO_STATUS 0x08
#define GPIO_MODE_CTL 0x40
#define GPIO_DIG_VIN_CTL 0x41
#define GPIO_DIG_PULL_CTL 0x42
#define GPIO_DIG_OUT_SRC_CTL 0x44
#define GPIO_DIG_OUT_CTL 0x45
#define GPIO_EN_CTL 0x46
/* GPIO bit values */
#define PERPH_EN_BIT 7
#define GPIO_STATUS_VAL_BIT 0
/* PON Peripheral registers */
#define PON_PON_REASON1 0x808
#define PON_WARMBOOT_STATUS1 0x80A
#define PON_WARMBOOT_STATUS2 0x80B
#define PON_POFF_REASON1 0x80C
#define PON_POFF_REASON2 0x80D
#define PON_INT_RT_STS 0x810
#define PON_INT_SET_TYPE 0x811
#define PON_INT_POLARITY_HIGH 0x812
#define PON_INT_POLARITY_LOW 0x813
#define PON_INT_LATCHED_CLR 0x814
#define PON_INT_EN_SET 0x815
#define PON_INT_LATCHED_STS 0x818
#define PON_INT_PENDING_STS 0x819
#define PON_RESIN_N_RESET_S1_TIMER 0x844 /* bits 0:3 : S1_TIMER */
#define PON_RESIN_N_RESET_S2_TIMER 0x845 /* bits 0:2 : S2_TIMER */
#define PON_RESIN_N_RESET_S2_CTL 0x846 /* bit 7: S2_RESET_EN, bit 0:3 : RESET_TYPE */
#define PON_PS_HOLD_RESET_CTL 0x85A /* bit 7: S2_RESET_EN, bit 0:3 : RESET_TYPE */
#define PON_PS_HOLD_RESET_CTL2 0x85B
#define PMIC_WD_RESET_S2_CTL2 0x857
/* PON Peripheral register bit values */
#define RESIN_ON_INT_BIT 1
#define KPDPWR_ON_INT_BIT 0
#define RESIN_BARK_INT_BIT 4
#define S2_RESET_EN_BIT 7
#define S2_RESET_TYPE_WARM 0x1
#define PON_RESIN_N_RESET_S2_TIMER_MAX_VALUE 0x7
/* USB Peripheral registers */
#define SMBCHGL_USB_ICL_STS_2 0x1309
/* PMI8950 slave id */
#define PMI8950_SLAVE_ID 0x20000
/* USB Peripheral register bits */
#define USBIN_ACTIVE_PWR_SRC BIT(0)
#define DCIN_ACTIVE_PWR_SRC BIT(1)
/* MPP registers */
#define MPP_DIG_VIN_CTL 0x41
#define MPP_MODE_CTL 0x40
#define MPP_EN_CTL 0x46
#define MPP_MODE_CTL_MODE_SHIFT 4
#define MPP_EN_CTL_ENABLE_SHIFT 7
/* MVS registers */
#define MVS_EN_CTL 0x46
#define MVS_EN_CTL_ENABLE_SHIFT 7
void pm8x41_reg_write(uint32_t addr, uint8_t val);
uint8_t pm8x41_reg_read(uint32_t addr);
/* SPMI Macros */
#define REG_READ(_a) pm8x41_reg_read(_a)
#define REG_WRITE(_a, _v) pm8x41_reg_write(_a, _v)
#define REG_OFFSET(_addr) ((_addr) & 0xFF)
#define PERIPH_ID(_addr) (((_addr) & 0xFF00) >> 8)
#define SLAVE_ID(_addr) ((_addr) >> 16)
#define LDO_RANGE_CTRL 0x40
#define LDO_STEP_CTRL 0x41
#define LDO_POWER_MODE 0x45
#define LDO_EN_CTL_REG 0x46
/* USB3 phy clock */
#define DIFF_CLK1_EN_CTL 0x5746
#define DIFF_CLK1_EN_BIT 7
#define LNBB_CLK_EN_CTL 0x5246
#define LNBB_CLK_EN_BIT 7
/* SMBB registers */
#define PM8XXX_IBAT_ATC_A 0x1054
#define PM8XXX_VBAT_DET 0x105D
#define PM8XXX_SEC_ACCESS 0x10D0
#define PM8XXX_COMP_OVR0 0x10ED
#define PM8XXX_VCP 0x1247
#define PM8XXX_TRKL_CHG_TEST 0x10E2
#define PM8XXX_VBAT_IN_TSTS 0x1010
/* Macros for broken battery */
#define VBAT_DET_LO_4_30V 0x35
#define SEC_ACCESS 0xa5
#define OVR0_DIS_VTRKL_FAULT 0x08
#define CHG_TRICKLE_FORCED_ON 0x01
#define VBAT_DET_HI_RT_STS 0x02
#define VCP_ENABLE 0x01
#define PMI8994_CHGR_CFG2 0x210FC
#define CURRENT_TERM_EN BIT(3)
#define PMI8994_FCC_CFG 0x210F2
#define PMI8994_FV_CFG 0x210F4
#define PMI8994_INT_RT_STS 0x21010
#define BAT_TAPER_MODE_CHARGING_RT_STS BIT(6)
#define PMI8994_CHGR_TRIM_OPTIONS_7_0 0x216F6
#define INPUT_MISSING_POLLER_EN BIT(3)
int pm8xxx_is_battery_broken(void);
bool pmi8994_battery_broken(void);
#endif