| /* |
| * Copyright (c) 2013-2015, The Linux Foundation. All rights reserved. |
| * |
| * Redistribution and use in source and binary forms, with or without |
| * modification, are permitted provided that the following conditions are met: |
| * * Redistributions of source code must retain the above copyright |
| * notice, this list of conditions and the following disclaimer. |
| * * Redistributions in binary form must reproduce the above copyright |
| * notice, this list of conditions and the following disclaimer in the |
| * documentation and/or other materials provided with the distribution. |
| * * Neither the name of Linux Foundation nor |
| * the names of its contributors may be used to endorse or promote |
| * products derived from this software without specific prior written |
| * permission. |
| * |
| * THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS "AS IS" |
| * AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE |
| * IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE AND |
| * NON-INFRINGEMENT ARE DISCLAIMED. IN NO EVENT SHALL THE COPYRIGHT OWNER OR |
| * CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, |
| * EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, |
| * PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; |
| * OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, |
| * WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR |
| * OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF |
| * ADVISED OF THE POSSIBILITY OF SUCH DAMAGE. |
| */ |
| |
| #include <err.h> |
| #include <assert.h> |
| #include <debug.h> |
| #include <reg.h> |
| #include <clock.h> |
| #include <mmc.h> |
| #include <platform/clock.h> |
| #include <platform/iomap.h> |
| #include <platform/timer.h> |
| #include <platform.h> |
| |
| void clock_config_uart_dm(uint8_t id) |
| { |
| int ret; |
| char clk_name[64]; |
| |
| snprintf(clk_name, sizeof(clk_name), "uart%u_iface_clk", id); |
| ret = clk_get_set_enable(clk_name, 0, 1); |
| if (ret) |
| { |
| dprintf(CRITICAL, "failed to set %s ret = %d\n", clk_name, ret); |
| ASSERT(0); |
| } |
| |
| snprintf(clk_name, sizeof(clk_name), "uart%u_core_clk", id); |
| ret = clk_get_set_enable(clk_name, 7372800, 1); |
| if (ret) |
| { |
| dprintf(CRITICAL, "failed to set %s ret = %d\n", clk_name, ret); |
| ASSERT(0); |
| } |
| } |
| |
| /* |
| * Disable power collapse using GDSCR: |
| * Globally Distributed Switch Controller Register |
| */ |
| void clock_usb30_gdsc_enable(void) |
| { |
| uint32_t reg = readl(GCC_USB30_GDSCR); |
| |
| reg &= ~(0x1); |
| |
| writel(reg, GCC_USB30_GDSCR); |
| } |
| |
| /* enables usb30 clocks */ |
| void clock_usb30_init(void) |
| { |
| int ret; |
| |
| ret = clk_get_set_enable("usb30_iface_clk", 0, 1); |
| if(ret) |
| { |
| dprintf(CRITICAL, "failed to set usb30_iface_clk. ret = %d\n", ret); |
| ASSERT(0); |
| } |
| |
| clock_usb30_gdsc_enable(); |
| |
| ret = clk_get_set_enable("usb30_master_clk", 125000000, 1); |
| if(ret) |
| { |
| dprintf(CRITICAL, "failed to set usb30_master_clk. ret = %d\n", ret); |
| ASSERT(0); |
| } |
| |
| if (platform_is_mdmcalifornium()) |
| ret = clk_get_set_enable("usb30_pipe_clk_mdmcalifornium", 0, 1); |
| else |
| ret = clk_get_set_enable("usb30_pipe_clk", 19200000, 1); |
| |
| if(ret) |
| { |
| dprintf(CRITICAL, "failed to set usb30_pipe_clk. ret = %d\n", ret); |
| ASSERT(0); |
| } |
| |
| ret = clk_get_set_enable("usb30_aux_clk", 1000000, 1); |
| if(ret) |
| { |
| dprintf(CRITICAL, "failed to set usb30_aux_clk. ret = %d\n", ret); |
| ASSERT(0); |
| } |
| |
| ret = clk_get_set_enable("usb30_mock_utmi_clk", 60000000, true); |
| if(ret) |
| { |
| dprintf(CRITICAL, "failed to set usb30_mock_utmi_clk ret = %d\n", ret); |
| ASSERT(0); |
| } |
| |
| ret = clk_get_set_enable("usb30_sleep_clk", 0, true); |
| if(ret) |
| { |
| dprintf(CRITICAL, "failed to set usb30_sleep_clk ret = %d\n", ret); |
| ASSERT(0); |
| } |
| |
| ret = clk_get_set_enable("usb_phy_cfg_ahb_clk", 0, 1); |
| if(ret) |
| { |
| dprintf(CRITICAL, "failed to set usb_phy_cfg_ahb_clk ret = %d\n", ret); |
| ASSERT(0); |
| } |
| } |
| |
| void clock_init_mmc(uint32_t interface) |
| { |
| char clk_name[64]; |
| int ret; |
| |
| snprintf(clk_name, sizeof(clk_name), "sdc%u_iface_clk", interface); |
| |
| /* enable interface clock */ |
| ret = clk_get_set_enable(clk_name, 0, 1); |
| if(ret) |
| { |
| dprintf(CRITICAL, "failed to set sdc1_iface_clk ret = %d\n", ret); |
| ASSERT(0); |
| } |
| } |
| |
| /* Configure MMC clock */ |
| void clock_config_mmc(uint32_t interface, uint32_t freq) |
| { |
| int ret = 0; |
| char clk_name[64]; |
| |
| snprintf(clk_name, sizeof(clk_name), "sdc%u_core_clk", interface); |
| |
| if(freq == MMC_CLK_400KHZ) |
| { |
| ret = clk_get_set_enable(clk_name, 400000, 1); |
| } |
| else if(freq == MMC_CLK_50MHZ) |
| { |
| ret = clk_get_set_enable(clk_name, 50000000, 1); |
| } |
| else if(freq == MMC_CLK_200MHZ) |
| { |
| ret = clk_get_set_enable(clk_name, 200000000, 1); |
| } |
| else if(freq == MMC_CLK_171MHZ) |
| { |
| ret = clk_get_set_enable(clk_name, 171430000, 1); |
| } |
| else |
| { |
| dprintf(CRITICAL, "sdc frequency (%u) is not supported\n", freq); |
| ASSERT(0); |
| } |
| |
| if(ret) |
| { |
| dprintf(CRITICAL, "failed to set %s ret = %d\n", clk_name, ret); |
| ASSERT(0); |
| } |
| } |
| |
| void clock_bumpup_pipe3_clk() |
| { |
| int ret =0; |
| |
| if (platform_is_mdmcalifornium()) |
| ret = clk_get_set_enable("usb30_pipe_clk", 0, true); |
| else |
| ret = clk_get_set_enable("usb30_pipe_clk", 125000000, true); |
| |
| if(ret) |
| { |
| dprintf(CRITICAL, "failed to set usb30_pipe_clk. ret = %d\n", ret); |
| ASSERT(0); |
| } |
| } |
| |
| void clock_reset_usb_phy() |
| { |
| int ret; |
| |
| struct clk *phy_reset_clk = NULL; |
| struct clk *pipe_reset_clk = NULL; |
| struct clk *master_clk = NULL; |
| |
| master_clk = clk_get("usb30_master_clk"); |
| ASSERT(master_clk); |
| |
| /* Look if phy com clock is present */ |
| phy_reset_clk = clk_get("usb30_phy_reset"); |
| ASSERT(phy_reset_clk); |
| |
| pipe_reset_clk = clk_get("usb30_pipe_clk"); |
| ASSERT(pipe_reset_clk); |
| |
| /* ASSERT */ |
| ret = clk_reset(master_clk, CLK_RESET_ASSERT); |
| if (ret) |
| { |
| dprintf(CRITICAL, "Failed to assert usb30_master_reset clk\n"); |
| return; |
| } |
| ret = clk_reset(phy_reset_clk, CLK_RESET_ASSERT); |
| |
| if (ret) |
| { |
| dprintf(CRITICAL, "Failed to assert usb30_phy_reset clk\n"); |
| goto deassert_master_clk; |
| } |
| |
| ret = clk_reset(pipe_reset_clk, CLK_RESET_ASSERT); |
| if (ret) |
| { |
| dprintf(CRITICAL, "Failed to assert usb30_pipe_clk\n"); |
| goto deassert_phy_clk; |
| } |
| |
| udelay(100); |
| |
| /* DEASSERT */ |
| ret = clk_reset(pipe_reset_clk, CLK_RESET_DEASSERT); |
| if (ret) |
| { |
| dprintf(CRITICAL, "Failed to deassert usb_pipe_clk\n"); |
| return; |
| } |
| |
| deassert_phy_clk: |
| |
| ret = clk_reset(phy_reset_clk, CLK_RESET_DEASSERT); |
| if (ret) |
| { |
| dprintf(CRITICAL, "Failed to deassert usb30_phy_com_reset clk\n"); |
| return; |
| } |
| deassert_master_clk: |
| |
| ret = clk_reset(master_clk, CLK_RESET_DEASSERT); |
| if (ret) |
| { |
| dprintf(CRITICAL, "Failed to deassert usb30_master clk\n"); |
| return; |
| } |
| |
| } |