| #include <linux/atomic.h> |
| #include <linux/clk.h> |
| #include <linux/delay.h> |
| #include <linux/device.h> |
| #include <linux/i2c.h> |
| #include <linux/i2c-smbus.h> |
| #include <linux/io.h> |
| #include <linux/kernel.h> |
| #include <linux/pci.h> |
| |
| /* Register offsets */ |
| #if IS_ENABLED(CONFIG_I2C_THUNDERX) |
| #define SW_TWSI 0x1000 |
| #define TWSI_INT 0x1010 |
| #define SW_TWSI_EXT 0x1018 |
| #else |
| #define SW_TWSI 0x00 |
| #define TWSI_INT 0x10 |
| #define SW_TWSI_EXT 0x18 |
| #endif |
| |
| /* Controller command patterns */ |
| #define SW_TWSI_V BIT_ULL(63) /* Valid bit */ |
| #define SW_TWSI_EIA BIT_ULL(61) /* Extended internal address */ |
| #define SW_TWSI_R BIT_ULL(56) /* Result or read bit */ |
| #define SW_TWSI_SOVR BIT_ULL(55) /* Size override */ |
| #define SW_TWSI_SIZE_SHIFT 52 |
| #define SW_TWSI_ADDR_SHIFT 40 |
| #define SW_TWSI_IA_SHIFT 32 /* Internal address */ |
| |
| /* Controller opcode word (bits 60:57) */ |
| #define SW_TWSI_OP_SHIFT 57 |
| #define SW_TWSI_OP_7 (0ULL << SW_TWSI_OP_SHIFT) |
| #define SW_TWSI_OP_7_IA (1ULL << SW_TWSI_OP_SHIFT) |
| #define SW_TWSI_OP_10 (2ULL << SW_TWSI_OP_SHIFT) |
| #define SW_TWSI_OP_10_IA (3ULL << SW_TWSI_OP_SHIFT) |
| #define SW_TWSI_OP_TWSI_CLK (4ULL << SW_TWSI_OP_SHIFT) |
| #define SW_TWSI_OP_EOP (6ULL << SW_TWSI_OP_SHIFT) /* Extended opcode */ |
| |
| /* Controller extended opcode word (bits 34:32) */ |
| #define SW_TWSI_EOP_SHIFT 32 |
| #define SW_TWSI_EOP_TWSI_DATA (SW_TWSI_OP_EOP | 1ULL << SW_TWSI_EOP_SHIFT) |
| #define SW_TWSI_EOP_TWSI_CTL (SW_TWSI_OP_EOP | 2ULL << SW_TWSI_EOP_SHIFT) |
| #define SW_TWSI_EOP_TWSI_CLKCTL (SW_TWSI_OP_EOP | 3ULL << SW_TWSI_EOP_SHIFT) |
| #define SW_TWSI_EOP_TWSI_STAT (SW_TWSI_OP_EOP | 3ULL << SW_TWSI_EOP_SHIFT) |
| #define SW_TWSI_EOP_TWSI_RST (SW_TWSI_OP_EOP | 7ULL << SW_TWSI_EOP_SHIFT) |
| |
| /* Controller command and status bits */ |
| #define TWSI_CTL_CE 0x80 /* High level controller enable */ |
| #define TWSI_CTL_ENAB 0x40 /* Bus enable */ |
| #define TWSI_CTL_STA 0x20 /* Master-mode start, HW clears when done */ |
| #define TWSI_CTL_STP 0x10 /* Master-mode stop, HW clears when done */ |
| #define TWSI_CTL_IFLG 0x08 /* HW event, SW writes 0 to ACK */ |
| #define TWSI_CTL_AAK 0x04 /* Assert ACK */ |
| |
| /* Status values */ |
| #define STAT_ERROR 0x00 |
| #define STAT_START 0x08 |
| #define STAT_REP_START 0x10 |
| #define STAT_TXADDR_ACK 0x18 |
| #define STAT_TXADDR_NAK 0x20 |
| #define STAT_TXDATA_ACK 0x28 |
| #define STAT_TXDATA_NAK 0x30 |
| #define STAT_LOST_ARB_38 0x38 |
| #define STAT_RXADDR_ACK 0x40 |
| #define STAT_RXADDR_NAK 0x48 |
| #define STAT_RXDATA_ACK 0x50 |
| #define STAT_RXDATA_NAK 0x58 |
| #define STAT_SLAVE_60 0x60 |
| #define STAT_LOST_ARB_68 0x68 |
| #define STAT_SLAVE_70 0x70 |
| #define STAT_LOST_ARB_78 0x78 |
| #define STAT_SLAVE_80 0x80 |
| #define STAT_SLAVE_88 0x88 |
| #define STAT_GENDATA_ACK 0x90 |
| #define STAT_GENDATA_NAK 0x98 |
| #define STAT_SLAVE_A0 0xA0 |
| #define STAT_SLAVE_A8 0xA8 |
| #define STAT_LOST_ARB_B0 0xB0 |
| #define STAT_SLAVE_LOST 0xB8 |
| #define STAT_SLAVE_NAK 0xC0 |
| #define STAT_SLAVE_ACK 0xC8 |
| #define STAT_AD2W_ACK 0xD0 |
| #define STAT_AD2W_NAK 0xD8 |
| #define STAT_IDLE 0xF8 |
| |
| /* TWSI_INT values */ |
| #define TWSI_INT_ST_INT BIT_ULL(0) |
| #define TWSI_INT_TS_INT BIT_ULL(1) |
| #define TWSI_INT_CORE_INT BIT_ULL(2) |
| #define TWSI_INT_ST_EN BIT_ULL(4) |
| #define TWSI_INT_TS_EN BIT_ULL(5) |
| #define TWSI_INT_CORE_EN BIT_ULL(6) |
| #define TWSI_INT_SDA_OVR BIT_ULL(8) |
| #define TWSI_INT_SCL_OVR BIT_ULL(9) |
| #define TWSI_INT_SDA BIT_ULL(10) |
| #define TWSI_INT_SCL BIT_ULL(11) |
| |
| #define I2C_OCTEON_EVENT_WAIT 80 /* microseconds */ |
| |
| struct octeon_i2c { |
| wait_queue_head_t queue; |
| struct i2c_adapter adap; |
| struct clk *clk; |
| int irq; |
| int hlc_irq; /* For cn7890 only */ |
| u32 twsi_freq; |
| int sys_freq; |
| void __iomem *twsi_base; |
| struct device *dev; |
| bool hlc_enabled; |
| bool broken_irq_mode; |
| bool broken_irq_check; |
| void (*int_enable)(struct octeon_i2c *); |
| void (*int_disable)(struct octeon_i2c *); |
| void (*hlc_int_enable)(struct octeon_i2c *); |
| void (*hlc_int_disable)(struct octeon_i2c *); |
| atomic_t int_enable_cnt; |
| atomic_t hlc_int_enable_cnt; |
| #if IS_ENABLED(CONFIG_I2C_THUNDERX) |
| struct msix_entry i2c_msix; |
| #endif |
| struct i2c_smbus_alert_setup alert_data; |
| struct i2c_client *ara; |
| }; |
| |
| static inline void octeon_i2c_writeq_flush(u64 val, void __iomem *addr) |
| { |
| __raw_writeq(val, addr); |
| __raw_readq(addr); /* wait for write to land */ |
| } |
| |
| /** |
| * octeon_i2c_reg_write - write an I2C core register |
| * @i2c: The struct octeon_i2c |
| * @eop_reg: Register selector |
| * @data: Value to be written |
| * |
| * The I2C core registers are accessed indirectly via the SW_TWSI CSR. |
| */ |
| static inline void octeon_i2c_reg_write(struct octeon_i2c *i2c, u64 eop_reg, u8 data) |
| { |
| u64 tmp; |
| |
| __raw_writeq(SW_TWSI_V | eop_reg | data, i2c->twsi_base + SW_TWSI); |
| do { |
| tmp = __raw_readq(i2c->twsi_base + SW_TWSI); |
| } while ((tmp & SW_TWSI_V) != 0); |
| } |
| |
| #define octeon_i2c_ctl_write(i2c, val) \ |
| octeon_i2c_reg_write(i2c, SW_TWSI_EOP_TWSI_CTL, val) |
| #define octeon_i2c_data_write(i2c, val) \ |
| octeon_i2c_reg_write(i2c, SW_TWSI_EOP_TWSI_DATA, val) |
| |
| /** |
| * octeon_i2c_reg_read - read lower bits of an I2C core register |
| * @i2c: The struct octeon_i2c |
| * @eop_reg: Register selector |
| * |
| * Returns the data. |
| * |
| * The I2C core registers are accessed indirectly via the SW_TWSI CSR. |
| */ |
| static inline u8 octeon_i2c_reg_read(struct octeon_i2c *i2c, u64 eop_reg) |
| { |
| u64 tmp; |
| |
| __raw_writeq(SW_TWSI_V | eop_reg | SW_TWSI_R, i2c->twsi_base + SW_TWSI); |
| do { |
| tmp = __raw_readq(i2c->twsi_base + SW_TWSI); |
| } while ((tmp & SW_TWSI_V) != 0); |
| |
| return tmp & 0xFF; |
| } |
| |
| #define octeon_i2c_ctl_read(i2c) \ |
| octeon_i2c_reg_read(i2c, SW_TWSI_EOP_TWSI_CTL) |
| #define octeon_i2c_data_read(i2c) \ |
| octeon_i2c_reg_read(i2c, SW_TWSI_EOP_TWSI_DATA) |
| #define octeon_i2c_stat_read(i2c) \ |
| octeon_i2c_reg_read(i2c, SW_TWSI_EOP_TWSI_STAT) |
| |
| /** |
| * octeon_i2c_read_int - read the TWSI_INT register |
| * @i2c: The struct octeon_i2c |
| * |
| * Returns the value of the register. |
| */ |
| static inline u64 octeon_i2c_read_int(struct octeon_i2c *i2c) |
| { |
| return __raw_readq(i2c->twsi_base + TWSI_INT); |
| } |
| |
| /** |
| * octeon_i2c_write_int - write the TWSI_INT register |
| * @i2c: The struct octeon_i2c |
| * @data: Value to be written |
| */ |
| static inline void octeon_i2c_write_int(struct octeon_i2c *i2c, u64 data) |
| { |
| octeon_i2c_writeq_flush(data, i2c->twsi_base + TWSI_INT); |
| } |
| |
| /* Prototypes */ |
| irqreturn_t octeon_i2c_isr(int irq, void *dev_id); |
| int octeon_i2c_xfer(struct i2c_adapter *adap, struct i2c_msg *msgs, int num); |
| int octeon_i2c_init_lowlevel(struct octeon_i2c *i2c); |
| void octeon_i2c_set_clock(struct octeon_i2c *i2c); |
| extern struct i2c_bus_recovery_info octeon_i2c_recovery_info; |