| config INFINIBAND_IPOIB |
| tristate "IP-over-InfiniBand" |
| depends on INFINIBAND && NETDEVICES && INET |
| ---help--- |
| Support for the IP-over-InfiniBand protocol (IPoIB). This |
| transports IP packets over InfiniBand so you can use your IB |
| device as a fancy NIC. |
| |
| The IPoIB protocol is defined by the IETF ipoib working |
| group: <http://www.ietf.org/html.charters/ipoib-charter.html>. |
| |
| config INFINIBAND_IPOIB_DEBUG |
| bool "IP-over-InfiniBand debugging" if EMBEDDED |
| depends on INFINIBAND_IPOIB |
| default y |
| ---help--- |
| This option causes debugging code to be compiled into the |
| IPoIB driver. The output can be turned on via the |
| debug_level and mcast_debug_level module parameters (which |
| can also be set after the driver is loaded through sysfs). |
| |
| This option also creates an "ipoib_debugfs," which can be |
| mounted to expose debugging information about IB multicast |
| groups used by the IPoIB driver. |
| |
| config INFINIBAND_IPOIB_DEBUG_DATA |
| bool "IP-over-InfiniBand data path debugging" |
| depends on INFINIBAND_IPOIB_DEBUG |
| ---help--- |
| This option compiles debugging code into the the data path |
| of the IPoIB driver. The output can be turned on via the |
| data_debug_level module parameter; however, even with output |
| turned off, this debugging code will have some performance |
| impact. |