| /* |
| * This program is free software; you can redistribute it and/or modify it |
| * under the terms of the GNU General Public License as published by the |
| * Free Software Foundation; either version 2 of the License, or (at your |
| * option) any later version. |
| * |
| * Copyright (C) 2003, 04 Ralf Baechle (ralf@linux-mips.org) |
| */ |
| #include <linux/kernel.h> |
| #include <linux/mm.h> |
| #include <linux/bootmem.h> |
| #include <linux/init.h> |
| #include <linux/types.h> |
| #include <linux/pci.h> |
| |
| /* |
| * Indicate whether we respect the PCI setup left by the firmware. |
| * |
| * Make this long-lived so that we know when shutting down |
| * whether we probed only or not. |
| */ |
| int pci_probe_only; |
| |
| #define PCI_ASSIGN_ALL_BUSSES 1 |
| |
| unsigned int pci_probe = PCI_ASSIGN_ALL_BUSSES; |
| |
| /* |
| * The PCI controller list. |
| */ |
| |
| struct pci_controller *hose_head, **hose_tail = &hose_head; |
| struct pci_controller *pci_isa_hose; |
| |
| unsigned long PCIBIOS_MIN_IO = 0x0000; |
| unsigned long PCIBIOS_MIN_MEM = 0; |
| |
| /* |
| * We need to avoid collisions with `mirrored' VGA ports |
| * and other strange ISA hardware, so we always want the |
| * addresses to be allocated in the 0x000-0x0ff region |
| * modulo 0x400. |
| * |
| * Why? Because some silly external IO cards only decode |
| * the low 10 bits of the IO address. The 0x00-0xff region |
| * is reserved for motherboard devices that decode all 16 |
| * bits, so it's ok to allocate at, say, 0x2800-0x28ff, |
| * but we want to try to avoid allocating at 0x2900-0x2bff |
| * which might have be mirrored at 0x0100-0x03ff.. |
| */ |
| void |
| pcibios_align_resource(void *data, struct resource *res, |
| resource_size_t size, resource_size_t align) |
| { |
| struct pci_dev *dev = data; |
| struct pci_controller *hose = dev->sysdata; |
| resource_size_t start = res->start; |
| |
| if (res->flags & IORESOURCE_IO) { |
| /* Make sure we start at our min on all hoses */ |
| if (start < PCIBIOS_MIN_IO + hose->io_resource->start) |
| start = PCIBIOS_MIN_IO + hose->io_resource->start; |
| |
| /* |
| * Put everything into 0x00-0xff region modulo 0x400 |
| */ |
| if (start & 0x300) |
| start = (start + 0x3ff) & ~0x3ff; |
| } else if (res->flags & IORESOURCE_MEM) { |
| /* Make sure we start at our min on all hoses */ |
| if (start < PCIBIOS_MIN_MEM + hose->mem_resource->start) |
| start = PCIBIOS_MIN_MEM + hose->mem_resource->start; |
| } |
| |
| res->start = start; |
| } |
| |
| void __devinit register_pci_controller(struct pci_controller *hose) |
| { |
| if (request_resource(&iomem_resource, hose->mem_resource) < 0) |
| goto out; |
| if (request_resource(&ioport_resource, hose->io_resource) < 0) { |
| release_resource(hose->mem_resource); |
| goto out; |
| } |
| |
| *hose_tail = hose; |
| hose_tail = &hose->next; |
| |
| /* |
| * Do not panic here but later - this might hapen before console init. |
| */ |
| if (!hose->io_map_base) { |
| printk(KERN_WARNING |
| "registering PCI controller with io_map_base unset\n"); |
| } |
| return; |
| |
| out: |
| printk(KERN_WARNING |
| "Skipping PCI bus scan due to resource conflict\n"); |
| } |
| |
| /* Most MIPS systems have straight-forward swizzling needs. */ |
| |
| static inline u8 bridge_swizzle(u8 pin, u8 slot) |
| { |
| return (((pin - 1) + slot) % 4) + 1; |
| } |
| |
| static u8 __init common_swizzle(struct pci_dev *dev, u8 *pinp) |
| { |
| u8 pin = *pinp; |
| |
| while (dev->bus->parent) { |
| pin = bridge_swizzle(pin, PCI_SLOT(dev->devfn)); |
| /* Move up the chain of bridges. */ |
| dev = dev->bus->self; |
| } |
| *pinp = pin; |
| |
| /* The slot is the slot of the last bridge. */ |
| return PCI_SLOT(dev->devfn); |
| } |
| |
| static int __init pcibios_init(void) |
| { |
| struct pci_controller *hose; |
| struct pci_bus *bus; |
| int next_busno; |
| int need_domain_info = 0; |
| |
| /* Scan all of the recorded PCI controllers. */ |
| for (next_busno = 0, hose = hose_head; hose; hose = hose->next) { |
| |
| if (!hose->iommu) |
| PCI_DMA_BUS_IS_PHYS = 1; |
| |
| if (hose->get_busno && pci_probe_only) |
| next_busno = (*hose->get_busno)(); |
| |
| bus = pci_scan_bus(next_busno, hose->pci_ops, hose); |
| hose->bus = bus; |
| need_domain_info = need_domain_info || hose->index; |
| hose->need_domain_info = need_domain_info; |
| if (bus) { |
| next_busno = bus->subordinate + 1; |
| /* Don't allow 8-bit bus number overflow inside the hose - |
| reserve some space for bridges. */ |
| if (next_busno > 224) { |
| next_busno = 0; |
| need_domain_info = 1; |
| } |
| } |
| } |
| |
| if (!pci_probe_only) |
| pci_assign_unassigned_resources(); |
| pci_fixup_irqs(common_swizzle, pcibios_map_irq); |
| |
| return 0; |
| } |
| |
| subsys_initcall(pcibios_init); |
| |
| static int pcibios_enable_resources(struct pci_dev *dev, int mask) |
| { |
| u16 cmd, old_cmd; |
| int idx; |
| struct resource *r; |
| |
| pci_read_config_word(dev, PCI_COMMAND, &cmd); |
| old_cmd = cmd; |
| for (idx=0; idx < PCI_NUM_RESOURCES; idx++) { |
| /* Only set up the requested stuff */ |
| if (!(mask & (1<<idx))) |
| continue; |
| |
| r = &dev->resource[idx]; |
| if (!r->start && r->end) { |
| printk(KERN_ERR "PCI: Device %s not available because of resource collisions\n", pci_name(dev)); |
| return -EINVAL; |
| } |
| if (r->flags & IORESOURCE_IO) |
| cmd |= PCI_COMMAND_IO; |
| if (r->flags & IORESOURCE_MEM) |
| cmd |= PCI_COMMAND_MEMORY; |
| } |
| if (dev->resource[PCI_ROM_RESOURCE].start) |
| cmd |= PCI_COMMAND_MEMORY; |
| if (cmd != old_cmd) { |
| printk("PCI: Enabling device %s (%04x -> %04x)\n", pci_name(dev), old_cmd, cmd); |
| pci_write_config_word(dev, PCI_COMMAND, cmd); |
| } |
| return 0; |
| } |
| |
| /* |
| * If we set up a device for bus mastering, we need to check the latency |
| * timer as certain crappy BIOSes forget to set it properly. |
| */ |
| unsigned int pcibios_max_latency = 255; |
| |
| void pcibios_set_master(struct pci_dev *dev) |
| { |
| u8 lat; |
| pci_read_config_byte(dev, PCI_LATENCY_TIMER, &lat); |
| if (lat < 16) |
| lat = (64 <= pcibios_max_latency) ? 64 : pcibios_max_latency; |
| else if (lat > pcibios_max_latency) |
| lat = pcibios_max_latency; |
| else |
| return; |
| printk(KERN_DEBUG "PCI: Setting latency timer of device %s to %d\n", |
| pci_name(dev), lat); |
| pci_write_config_byte(dev, PCI_LATENCY_TIMER, lat); |
| } |
| |
| unsigned int pcibios_assign_all_busses(void) |
| { |
| return (pci_probe & PCI_ASSIGN_ALL_BUSSES) ? 1 : 0; |
| } |
| |
| int pcibios_enable_device(struct pci_dev *dev, int mask) |
| { |
| int err; |
| |
| if ((err = pcibios_enable_resources(dev, mask)) < 0) |
| return err; |
| |
| return pcibios_plat_dev_init(dev); |
| } |
| |
| static void pcibios_fixup_device_resources(struct pci_dev *dev, |
| struct pci_bus *bus) |
| { |
| /* Update device resources. */ |
| struct pci_controller *hose = (struct pci_controller *)bus->sysdata; |
| unsigned long offset = 0; |
| int i; |
| |
| for (i = 0; i < PCI_NUM_RESOURCES; i++) { |
| if (!dev->resource[i].start) |
| continue; |
| if (dev->resource[i].flags & IORESOURCE_PCI_FIXED) |
| continue; |
| if (dev->resource[i].flags & IORESOURCE_IO) |
| offset = hose->io_offset; |
| else if (dev->resource[i].flags & IORESOURCE_MEM) |
| offset = hose->mem_offset; |
| |
| dev->resource[i].start += offset; |
| dev->resource[i].end += offset; |
| } |
| } |
| |
| void pcibios_fixup_bus(struct pci_bus *bus) |
| { |
| /* Propagate hose info into the subordinate devices. */ |
| |
| struct pci_controller *hose = bus->sysdata; |
| struct list_head *ln; |
| struct pci_dev *dev = bus->self; |
| |
| if (!dev) { |
| bus->resource[0] = hose->io_resource; |
| bus->resource[1] = hose->mem_resource; |
| } else if (pci_probe_only && |
| (dev->class >> 8) == PCI_CLASS_BRIDGE_PCI) { |
| pci_read_bridge_bases(bus); |
| pcibios_fixup_device_resources(dev, bus); |
| } |
| |
| for (ln = bus->devices.next; ln != &bus->devices; ln = ln->next) { |
| dev = pci_dev_b(ln); |
| |
| if ((dev->class >> 8) != PCI_CLASS_BRIDGE_PCI) |
| pcibios_fixup_device_resources(dev, bus); |
| } |
| } |
| |
| void __init |
| pcibios_update_irq(struct pci_dev *dev, int irq) |
| { |
| pci_write_config_byte(dev, PCI_INTERRUPT_LINE, irq); |
| } |
| |
| void pcibios_resource_to_bus(struct pci_dev *dev, struct pci_bus_region *region, |
| struct resource *res) |
| { |
| struct pci_controller *hose = (struct pci_controller *)dev->sysdata; |
| unsigned long offset = 0; |
| |
| if (res->flags & IORESOURCE_IO) |
| offset = hose->io_offset; |
| else if (res->flags & IORESOURCE_MEM) |
| offset = hose->mem_offset; |
| |
| region->start = res->start - offset; |
| region->end = res->end - offset; |
| } |
| |
| void __devinit |
| pcibios_bus_to_resource(struct pci_dev *dev, struct resource *res, |
| struct pci_bus_region *region) |
| { |
| struct pci_controller *hose = (struct pci_controller *)dev->sysdata; |
| unsigned long offset = 0; |
| |
| if (res->flags & IORESOURCE_IO) |
| offset = hose->io_offset; |
| else if (res->flags & IORESOURCE_MEM) |
| offset = hose->mem_offset; |
| |
| res->start = region->start + offset; |
| res->end = region->end + offset; |
| } |
| |
| #ifdef CONFIG_HOTPLUG |
| EXPORT_SYMBOL(pcibios_resource_to_bus); |
| EXPORT_SYMBOL(pcibios_bus_to_resource); |
| EXPORT_SYMBOL(PCIBIOS_MIN_IO); |
| EXPORT_SYMBOL(PCIBIOS_MIN_MEM); |
| #endif |
| |
| char *pcibios_setup(char *str) |
| { |
| return str; |
| } |