| /* |
| * Xilinx Spartan6 Slave Serial SPI Driver |
| * |
| * Copyright (C) 2017 DENX Software Engineering |
| * |
| * Anatolij Gustschin <agust@denx.de> |
| * |
| * This program is free software; you can redistribute it and/or modify it |
| * under the terms and conditions of the GNU General Public License, |
| * version 2, as published by the Free Software Foundation. |
| * |
| * Manage Xilinx FPGA firmware that is loaded over SPI using |
| * the slave serial configuration interface. |
| */ |
| |
| #include <linux/delay.h> |
| #include <linux/device.h> |
| #include <linux/fpga/fpga-mgr.h> |
| #include <linux/gpio/consumer.h> |
| #include <linux/module.h> |
| #include <linux/mod_devicetable.h> |
| #include <linux/of.h> |
| #include <linux/spi/spi.h> |
| #include <linux/sizes.h> |
| |
| struct xilinx_spi_conf { |
| struct spi_device *spi; |
| struct gpio_desc *prog_b; |
| struct gpio_desc *done; |
| }; |
| |
| static enum fpga_mgr_states xilinx_spi_state(struct fpga_manager *mgr) |
| { |
| struct xilinx_spi_conf *conf = mgr->priv; |
| |
| if (!gpiod_get_value(conf->done)) |
| return FPGA_MGR_STATE_RESET; |
| |
| return FPGA_MGR_STATE_UNKNOWN; |
| } |
| |
| static int xilinx_spi_write_init(struct fpga_manager *mgr, |
| struct fpga_image_info *info, |
| const char *buf, size_t count) |
| { |
| struct xilinx_spi_conf *conf = mgr->priv; |
| const size_t prog_latency_7500us = 7500; |
| const size_t prog_pulse_1us = 1; |
| |
| if (info->flags & FPGA_MGR_PARTIAL_RECONFIG) { |
| dev_err(&mgr->dev, "Partial reconfiguration not supported.\n"); |
| return -EINVAL; |
| } |
| |
| gpiod_set_value(conf->prog_b, 1); |
| |
| udelay(prog_pulse_1us); /* min is 500 ns */ |
| |
| gpiod_set_value(conf->prog_b, 0); |
| |
| if (gpiod_get_value(conf->done)) { |
| dev_err(&mgr->dev, "Unexpected DONE pin state...\n"); |
| return -EIO; |
| } |
| |
| /* program latency */ |
| usleep_range(prog_latency_7500us, prog_latency_7500us + 100); |
| return 0; |
| } |
| |
| static int xilinx_spi_write(struct fpga_manager *mgr, const char *buf, |
| size_t count) |
| { |
| struct xilinx_spi_conf *conf = mgr->priv; |
| const char *fw_data = buf; |
| const char *fw_data_end = fw_data + count; |
| |
| while (fw_data < fw_data_end) { |
| size_t remaining, stride; |
| int ret; |
| |
| remaining = fw_data_end - fw_data; |
| stride = min_t(size_t, remaining, SZ_4K); |
| |
| ret = spi_write(conf->spi, fw_data, stride); |
| if (ret) { |
| dev_err(&mgr->dev, "SPI error in firmware write: %d\n", |
| ret); |
| return ret; |
| } |
| fw_data += stride; |
| } |
| |
| return 0; |
| } |
| |
| static int xilinx_spi_apply_cclk_cycles(struct xilinx_spi_conf *conf) |
| { |
| struct spi_device *spi = conf->spi; |
| const u8 din_data[1] = { 0xff }; |
| int ret; |
| |
| ret = spi_write(conf->spi, din_data, sizeof(din_data)); |
| if (ret) |
| dev_err(&spi->dev, "applying CCLK cycles failed: %d\n", ret); |
| |
| return ret; |
| } |
| |
| static int xilinx_spi_write_complete(struct fpga_manager *mgr, |
| struct fpga_image_info *info) |
| { |
| struct xilinx_spi_conf *conf = mgr->priv; |
| unsigned long timeout; |
| int ret; |
| |
| if (gpiod_get_value(conf->done)) |
| return xilinx_spi_apply_cclk_cycles(conf); |
| |
| timeout = jiffies + usecs_to_jiffies(info->config_complete_timeout_us); |
| |
| while (time_before(jiffies, timeout)) { |
| |
| ret = xilinx_spi_apply_cclk_cycles(conf); |
| if (ret) |
| return ret; |
| |
| if (gpiod_get_value(conf->done)) |
| return xilinx_spi_apply_cclk_cycles(conf); |
| } |
| |
| dev_err(&mgr->dev, "Timeout after config data transfer.\n"); |
| return -ETIMEDOUT; |
| } |
| |
| static const struct fpga_manager_ops xilinx_spi_ops = { |
| .state = xilinx_spi_state, |
| .write_init = xilinx_spi_write_init, |
| .write = xilinx_spi_write, |
| .write_complete = xilinx_spi_write_complete, |
| }; |
| |
| static int xilinx_spi_probe(struct spi_device *spi) |
| { |
| struct xilinx_spi_conf *conf; |
| |
| conf = devm_kzalloc(&spi->dev, sizeof(*conf), GFP_KERNEL); |
| if (!conf) |
| return -ENOMEM; |
| |
| conf->spi = spi; |
| |
| /* PROGRAM_B is active low */ |
| conf->prog_b = devm_gpiod_get(&spi->dev, "prog_b", GPIOD_OUT_LOW); |
| if (IS_ERR(conf->prog_b)) { |
| dev_err(&spi->dev, "Failed to get PROGRAM_B gpio: %ld\n", |
| PTR_ERR(conf->prog_b)); |
| return PTR_ERR(conf->prog_b); |
| } |
| |
| conf->done = devm_gpiod_get(&spi->dev, "done", GPIOD_IN); |
| if (IS_ERR(conf->done)) { |
| dev_err(&spi->dev, "Failed to get DONE gpio: %ld\n", |
| PTR_ERR(conf->done)); |
| return PTR_ERR(conf->done); |
| } |
| |
| return fpga_mgr_register(&spi->dev, "Xilinx Slave Serial FPGA Manager", |
| &xilinx_spi_ops, conf); |
| } |
| |
| static int xilinx_spi_remove(struct spi_device *spi) |
| { |
| fpga_mgr_unregister(&spi->dev); |
| |
| return 0; |
| } |
| |
| static const struct of_device_id xlnx_spi_of_match[] = { |
| { .compatible = "xlnx,fpga-slave-serial", }, |
| {} |
| }; |
| MODULE_DEVICE_TABLE(of, xlnx_spi_of_match); |
| |
| static struct spi_driver xilinx_slave_spi_driver = { |
| .driver = { |
| .name = "xlnx-slave-spi", |
| .of_match_table = of_match_ptr(xlnx_spi_of_match), |
| }, |
| .probe = xilinx_spi_probe, |
| .remove = xilinx_spi_remove, |
| }; |
| |
| module_spi_driver(xilinx_slave_spi_driver) |
| |
| MODULE_LICENSE("GPL v2"); |
| MODULE_AUTHOR("Anatolij Gustschin <agust@denx.de>"); |
| MODULE_DESCRIPTION("Load Xilinx FPGA firmware over SPI"); |