| # |
| # Atmel device configuration |
| # |
| |
| config NET_CADENCE |
| bool "Cadence devices" |
| depends on HAS_IOMEM && (ARM || AVR32 || COMPILE_TEST) |
| default y |
| ---help--- |
| If you have a network (Ethernet) card belonging to this class, say Y. |
| Make sure you know the name of your card. Read the Ethernet-HOWTO, |
| available from <http://www.tldp.org/docs.html#howto>. |
| |
| If unsure, say Y. |
| |
| Note that the answer to this question doesn't directly affect the |
| kernel: saying N will just cause the configurator to skip all |
| the remaining Atmel network card questions. If you say Y, you will be |
| asked for your specific card in the following questions. |
| |
| if NET_CADENCE |
| |
| config ARM_AT91_ETHER |
| tristate "AT91RM9200 Ethernet support" |
| depends on HAS_DMA && (ARCH_AT91RM9200 || COMPILE_TEST) |
| select MACB |
| ---help--- |
| If you wish to compile a kernel for the AT91RM9200 and enable |
| ethernet support, then you should always answer Y to this. |
| |
| config MACB |
| tristate "Cadence MACB/GEM support" |
| depends on HAS_DMA && (PLATFORM_AT32AP || ARCH_AT91 || ARCH_PICOXCELL || ARCH_ZYNQ || COMPILE_TEST) |
| select PHYLIB |
| ---help--- |
| The Cadence MACB ethernet interface is found on many Atmel AT32 and |
| AT91 parts. This driver also supports the Cadence GEM (Gigabit |
| Ethernet MAC found in some ARM SoC devices). Note: the Gigabit mode |
| is not yet supported. Say Y to include support for the MACB/GEM chip. |
| |
| To compile this driver as a module, choose M here: the module |
| will be called macb. |
| |
| endif # NET_CADENCE |