| /* |
| * linux/arch/arm/mach-imx/time.c |
| * |
| * Copyright (C) 2000-2001 Deep Blue Solutions |
| * Copyright (C) 2002 Shane Nay (shane@minirl.com) |
| * Copyright (C) 2006-2007 Pavel Pisa (ppisa@pikron.com) |
| * |
| * This program is free software; you can redistribute it and/or modify |
| * it under the terms of the GNU General Public License version 2 as |
| * published by the Free Software Foundation. |
| */ |
| #include <linux/kernel.h> |
| #include <linux/sched.h> |
| #include <linux/init.h> |
| #include <linux/interrupt.h> |
| #include <linux/irq.h> |
| #include <linux/time.h> |
| #include <linux/clocksource.h> |
| #include <linux/clockchips.h> |
| #include <linux/clk.h> |
| #include <linux/io.h> |
| |
| #include <mach/hardware.h> |
| #include <asm/leds.h> |
| #include <asm/irq.h> |
| #include <asm/mach/time.h> |
| |
| /* Use timer 1 as system timer */ |
| #define TIMER_BASE IMX_TIM1_BASE |
| |
| static struct clock_event_device clockevent_imx; |
| static enum clock_event_mode clockevent_mode = CLOCK_EVT_MODE_UNUSED; |
| |
| /* |
| * IRQ handler for the timer |
| */ |
| static irqreturn_t |
| imx_timer_interrupt(int irq, void *dev_id) |
| { |
| struct clock_event_device *evt = &clockevent_imx; |
| uint32_t tstat; |
| irqreturn_t ret = IRQ_NONE; |
| |
| /* clear the interrupt */ |
| tstat = IMX_TSTAT(TIMER_BASE); |
| IMX_TSTAT(TIMER_BASE) = 0; |
| |
| if (tstat & TSTAT_COMP) { |
| evt->event_handler(evt); |
| ret = IRQ_HANDLED; |
| } |
| |
| return ret; |
| } |
| |
| static struct irqaction imx_timer_irq = { |
| .name = "i.MX Timer Tick", |
| .flags = IRQF_DISABLED | IRQF_TIMER | IRQF_IRQPOLL, |
| .handler = imx_timer_interrupt, |
| }; |
| |
| /* |
| * Set up timer hardware into expected mode and state. |
| */ |
| static void __init imx_timer_hardware_init(void) |
| { |
| /* |
| * Initialise to a known state (all timers off, and timing reset) |
| */ |
| IMX_TCTL(TIMER_BASE) = 0; |
| IMX_TPRER(TIMER_BASE) = 0; |
| |
| IMX_TCTL(TIMER_BASE) = TCTL_FRR | TCTL_CLK_PCLK1 | TCTL_TEN; |
| } |
| |
| cycle_t imx_get_cycles(void) |
| { |
| return IMX_TCN(TIMER_BASE); |
| } |
| |
| static struct clocksource clocksource_imx = { |
| .name = "imx_timer1", |
| .rating = 200, |
| .read = imx_get_cycles, |
| .mask = 0xFFFFFFFF, |
| .shift = 20, |
| .flags = CLOCK_SOURCE_IS_CONTINUOUS, |
| }; |
| |
| static int __init imx_clocksource_init(unsigned long rate) |
| { |
| clocksource_imx.mult = |
| clocksource_hz2mult(rate, clocksource_imx.shift); |
| clocksource_register(&clocksource_imx); |
| |
| return 0; |
| } |
| |
| static int imx_set_next_event(unsigned long evt, |
| struct clock_event_device *unused) |
| { |
| unsigned long tcmp; |
| |
| tcmp = IMX_TCN(TIMER_BASE) + evt; |
| IMX_TCMP(TIMER_BASE) = tcmp; |
| |
| return (int32_t)(tcmp - IMX_TCN(TIMER_BASE)) < 0 ? -ETIME : 0; |
| } |
| |
| #ifdef DEBUG |
| static const char *clock_event_mode_label[]={ |
| [CLOCK_EVT_MODE_PERIODIC] = "CLOCK_EVT_MODE_PERIODIC", |
| [CLOCK_EVT_MODE_ONESHOT] = "CLOCK_EVT_MODE_ONESHOT", |
| [CLOCK_EVT_MODE_SHUTDOWN] = "CLOCK_EVT_MODE_SHUTDOWN", |
| [CLOCK_EVT_MODE_UNUSED] = "CLOCK_EVT_MODE_UNUSED" |
| }; |
| #endif /*DEBUG*/ |
| |
| static void imx_set_mode(enum clock_event_mode mode, struct clock_event_device *evt) |
| { |
| unsigned long flags; |
| |
| /* |
| * The timer interrupt generation is disabled at least |
| * for enough time to call imx_set_next_event() |
| */ |
| local_irq_save(flags); |
| /* Disable interrupt in GPT module */ |
| IMX_TCTL(TIMER_BASE) &= ~TCTL_IRQEN; |
| if (mode != clockevent_mode) { |
| /* Set event time into far-far future */ |
| IMX_TCMP(TIMER_BASE) = IMX_TCN(TIMER_BASE) - 3; |
| /* Clear pending interrupt */ |
| IMX_TSTAT(TIMER_BASE) &= ~TSTAT_COMP; |
| } |
| |
| #ifdef DEBUG |
| printk(KERN_INFO "imx_set_mode: changing mode from %s to %s\n", |
| clock_event_mode_label[clockevent_mode], clock_event_mode_label[mode]); |
| #endif /*DEBUG*/ |
| |
| /* Remember timer mode */ |
| clockevent_mode = mode; |
| local_irq_restore(flags); |
| |
| switch (mode) { |
| case CLOCK_EVT_MODE_PERIODIC: |
| printk(KERN_ERR "imx_set_mode: Periodic mode is not supported for i.MX\n"); |
| break; |
| case CLOCK_EVT_MODE_ONESHOT: |
| /* |
| * Do not put overhead of interrupt enable/disable into |
| * imx_set_next_event(), the core has about 4 minutes |
| * to call imx_set_next_event() or shutdown clock after |
| * mode switching |
| */ |
| local_irq_save(flags); |
| IMX_TCTL(TIMER_BASE) |= TCTL_IRQEN; |
| local_irq_restore(flags); |
| break; |
| case CLOCK_EVT_MODE_SHUTDOWN: |
| case CLOCK_EVT_MODE_UNUSED: |
| case CLOCK_EVT_MODE_RESUME: |
| /* Left event sources disabled, no more interrupts appears */ |
| break; |
| } |
| } |
| |
| static struct clock_event_device clockevent_imx = { |
| .name = "imx_timer1", |
| .features = CLOCK_EVT_FEAT_ONESHOT, |
| .shift = 32, |
| .set_mode = imx_set_mode, |
| .set_next_event = imx_set_next_event, |
| .rating = 200, |
| }; |
| |
| static int __init imx_clockevent_init(unsigned long rate) |
| { |
| clockevent_imx.mult = div_sc(rate, NSEC_PER_SEC, |
| clockevent_imx.shift); |
| clockevent_imx.max_delta_ns = |
| clockevent_delta2ns(0xfffffffe, &clockevent_imx); |
| clockevent_imx.min_delta_ns = |
| clockevent_delta2ns(0xf, &clockevent_imx); |
| |
| clockevent_imx.cpumask = cpumask_of(0); |
| |
| clockevents_register_device(&clockevent_imx); |
| |
| return 0; |
| } |
| |
| extern int imx_clocks_init(void); |
| |
| static void __init imx_timer_init(void) |
| { |
| struct clk *clk; |
| unsigned long rate; |
| |
| imx_clocks_init(); |
| |
| clk = clk_get(NULL, "perclk1"); |
| clk_enable(clk); |
| rate = clk_get_rate(clk); |
| |
| imx_timer_hardware_init(); |
| imx_clocksource_init(rate); |
| |
| imx_clockevent_init(rate); |
| |
| /* |
| * Make irqs happen for the system timer |
| */ |
| setup_irq(TIM1_INT, &imx_timer_irq); |
| } |
| |
| struct sys_timer imx_timer = { |
| .init = imx_timer_init, |
| }; |