| Linus Torvalds | 1da177e | 2005-04-16 15:20:36 -0700 | [diff] [blame^] | 1 | /* |
| 2 | Written 1994 by David C. Davies. |
| 3 | |
| 4 | Copyright 1994 David C. Davies. This software may be used and distributed |
| 5 | according to the terms of the GNU General Public License, incorporated herein by |
| 6 | reference. |
| 7 | */ |
| 8 | |
| 9 | /* |
| 10 | ** I/O addresses. Note that the 2k buffer option is not supported in |
| 11 | ** this driver. |
| 12 | */ |
| 13 | #define DEPCA_NICSR ioaddr+0x00 /* Network interface CSR */ |
| 14 | #define DEPCA_RBI ioaddr+0x02 /* RAM buffer index (2k buffer mode) */ |
| 15 | #define DEPCA_DATA ioaddr+0x04 /* LANCE registers' data port */ |
| 16 | #define DEPCA_ADDR ioaddr+0x06 /* LANCE registers' address port */ |
| 17 | #define DEPCA_HBASE ioaddr+0x08 /* EISA high memory base address reg. */ |
| 18 | #define DEPCA_PROM ioaddr+0x0c /* Ethernet address ROM data port */ |
| 19 | #define DEPCA_CNFG ioaddr+0x0c /* EISA Configuration port */ |
| 20 | #define DEPCA_RBSA ioaddr+0x0e /* RAM buffer starting address (2k buff.) */ |
| 21 | |
| 22 | /* |
| 23 | ** These are LANCE registers addressable through DEPCA_ADDR |
| 24 | */ |
| 25 | #define CSR0 0 |
| 26 | #define CSR1 1 |
| 27 | #define CSR2 2 |
| 28 | #define CSR3 3 |
| 29 | |
| 30 | /* |
| 31 | ** NETWORK INTERFACE CSR (NI_CSR) bit definitions |
| 32 | */ |
| 33 | |
| 34 | #define TO 0x0100 /* Time Out for remote boot */ |
| 35 | #define SHE 0x0080 /* SHadow memory Enable */ |
| 36 | #define BS 0x0040 /* Bank Select */ |
| 37 | #define BUF 0x0020 /* BUFfer size (1->32k, 0->64k) */ |
| 38 | #define RBE 0x0010 /* Remote Boot Enable (1->net boot) */ |
| 39 | #define AAC 0x0008 /* Address ROM Address Counter (1->enable) */ |
| 40 | #define _128KB 0x0008 /* 128kB Network RAM (1->enable) */ |
| 41 | #define IM 0x0004 /* Interrupt Mask (1->mask) */ |
| 42 | #define IEN 0x0002 /* Interrupt tristate ENable (1->enable) */ |
| 43 | #define LED 0x0001 /* LED control */ |
| 44 | |
| 45 | /* |
| 46 | ** Control and Status Register 0 (CSR0) bit definitions |
| 47 | */ |
| 48 | |
| 49 | #define ERR 0x8000 /* Error summary */ |
| 50 | #define BABL 0x4000 /* Babble transmitter timeout error */ |
| 51 | #define CERR 0x2000 /* Collision Error */ |
| 52 | #define MISS 0x1000 /* Missed packet */ |
| 53 | #define MERR 0x0800 /* Memory Error */ |
| 54 | #define RINT 0x0400 /* Receiver Interrupt */ |
| 55 | #define TINT 0x0200 /* Transmit Interrupt */ |
| 56 | #define IDON 0x0100 /* Initialization Done */ |
| 57 | #define INTR 0x0080 /* Interrupt Flag */ |
| 58 | #define INEA 0x0040 /* Interrupt Enable */ |
| 59 | #define RXON 0x0020 /* Receiver on */ |
| 60 | #define TXON 0x0010 /* Transmitter on */ |
| 61 | #define TDMD 0x0008 /* Transmit Demand */ |
| 62 | #define STOP 0x0004 /* Stop */ |
| 63 | #define STRT 0x0002 /* Start */ |
| 64 | #define INIT 0x0001 /* Initialize */ |
| 65 | #define INTM 0xff00 /* Interrupt Mask */ |
| 66 | #define INTE 0xfff0 /* Interrupt Enable */ |
| 67 | |
| 68 | /* |
| 69 | ** CONTROL AND STATUS REGISTER 3 (CSR3) |
| 70 | */ |
| 71 | |
| 72 | #define BSWP 0x0004 /* Byte SWaP */ |
| 73 | #define ACON 0x0002 /* ALE control */ |
| 74 | #define BCON 0x0001 /* Byte CONtrol */ |
| 75 | |
| 76 | /* |
| 77 | ** Initialization Block Mode Register |
| 78 | */ |
| 79 | |
| 80 | #define PROM 0x8000 /* Promiscuous Mode */ |
| 81 | #define EMBA 0x0080 /* Enable Modified Back-off Algorithm */ |
| 82 | #define INTL 0x0040 /* Internal Loopback */ |
| 83 | #define DRTY 0x0020 /* Disable Retry */ |
| 84 | #define COLL 0x0010 /* Force Collision */ |
| 85 | #define DTCR 0x0008 /* Disable Transmit CRC */ |
| 86 | #define LOOP 0x0004 /* Loopback */ |
| 87 | #define DTX 0x0002 /* Disable the Transmitter */ |
| 88 | #define DRX 0x0001 /* Disable the Receiver */ |
| 89 | |
| 90 | /* |
| 91 | ** Receive Message Descriptor 1 (RMD1) bit definitions. |
| 92 | */ |
| 93 | |
| 94 | #define R_OWN 0x80000000 /* Owner bit 0 = host, 1 = lance */ |
| 95 | #define R_ERR 0x4000 /* Error Summary */ |
| 96 | #define R_FRAM 0x2000 /* Framing Error */ |
| 97 | #define R_OFLO 0x1000 /* Overflow Error */ |
| 98 | #define R_CRC 0x0800 /* CRC Error */ |
| 99 | #define R_BUFF 0x0400 /* Buffer Error */ |
| 100 | #define R_STP 0x0200 /* Start of Packet */ |
| 101 | #define R_ENP 0x0100 /* End of Packet */ |
| 102 | |
| 103 | /* |
| 104 | ** Transmit Message Descriptor 1 (TMD1) bit definitions. |
| 105 | */ |
| 106 | |
| 107 | #define T_OWN 0x80000000 /* Owner bit 0 = host, 1 = lance */ |
| 108 | #define T_ERR 0x4000 /* Error Summary */ |
| 109 | #define T_ADD_FCS 0x2000 /* More the 1 retry needed to Xmit */ |
| 110 | #define T_MORE 0x1000 /* >1 retry to transmit packet */ |
| 111 | #define T_ONE 0x0800 /* 1 try needed to transmit the packet */ |
| 112 | #define T_DEF 0x0400 /* Deferred */ |
| 113 | #define T_STP 0x02000000 /* Start of Packet */ |
| 114 | #define T_ENP 0x01000000 /* End of Packet */ |
| 115 | #define T_FLAGS 0xff000000 /* TX Flags Field */ |
| 116 | |
| 117 | /* |
| 118 | ** Transmit Message Descriptor 3 (TMD3) bit definitions. |
| 119 | */ |
| 120 | |
| 121 | #define TMD3_BUFF 0x8000 /* BUFFer error */ |
| 122 | #define TMD3_UFLO 0x4000 /* UnderFLOw error */ |
| 123 | #define TMD3_RES 0x2000 /* REServed */ |
| 124 | #define TMD3_LCOL 0x1000 /* Late COLlision */ |
| 125 | #define TMD3_LCAR 0x0800 /* Loss of CARrier */ |
| 126 | #define TMD3_RTRY 0x0400 /* ReTRY error */ |
| 127 | |
| 128 | /* |
| 129 | ** EISA configuration Register (CNFG) bit definitions |
| 130 | */ |
| 131 | |
| 132 | #define TIMEOUT 0x0100 /* 0:2.5 mins, 1: 30 secs */ |
| 133 | #define REMOTE 0x0080 /* Remote Boot Enable -> 1 */ |
| 134 | #define IRQ11 0x0040 /* Enable -> 1 */ |
| 135 | #define IRQ10 0x0020 /* Enable -> 1 */ |
| 136 | #define IRQ9 0x0010 /* Enable -> 1 */ |
| 137 | #define IRQ5 0x0008 /* Enable -> 1 */ |
| 138 | #define BUFF 0x0004 /* 0: 64kB or 128kB, 1: 32kB */ |
| 139 | #define PADR16 0x0002 /* RAM on 64kB boundary */ |
| 140 | #define PADR17 0x0001 /* RAM on 128kB boundary */ |
| 141 | |
| 142 | /* |
| 143 | ** Miscellaneous |
| 144 | */ |
| 145 | #define HASH_TABLE_LEN 64 /* Bits */ |
| 146 | #define HASH_BITS 0x003f /* 6 LS bits */ |
| 147 | |
| 148 | #define MASK_INTERRUPTS 1 |
| 149 | #define UNMASK_INTERRUPTS 0 |
| 150 | |
| 151 | #define EISA_EN 0x0001 /* Enable EISA bus buffers */ |
| 152 | #define EISA_ID iobase+0x0080 /* ID long word for EISA card */ |
| 153 | #define EISA_CTRL iobase+0x0084 /* Control word for EISA card */ |
| 154 | |
| 155 | /* |
| 156 | ** Include the IOCTL stuff |
| 157 | */ |
| 158 | #include <linux/sockios.h> |
| 159 | |
| 160 | #define DEPCAIOCTL SIOCDEVPRIVATE |
| 161 | |
| 162 | struct depca_ioctl { |
| 163 | unsigned short cmd; /* Command to run */ |
| 164 | unsigned short len; /* Length of the data buffer */ |
| 165 | unsigned char __user *data; /* Pointer to the data buffer */ |
| 166 | }; |
| 167 | |
| 168 | /* |
| 169 | ** Recognised commands for the driver |
| 170 | */ |
| 171 | #define DEPCA_GET_HWADDR 0x01 /* Get the hardware address */ |
| 172 | #define DEPCA_SET_HWADDR 0x02 /* Get the hardware address */ |
| 173 | #define DEPCA_SET_PROM 0x03 /* Set Promiscuous Mode */ |
| 174 | #define DEPCA_CLR_PROM 0x04 /* Clear Promiscuous Mode */ |
| 175 | #define DEPCA_SAY_BOO 0x05 /* Say "Boo!" to the kernel log file */ |
| 176 | #define DEPCA_GET_MCA 0x06 /* Get a multicast address */ |
| 177 | #define DEPCA_SET_MCA 0x07 /* Set a multicast address */ |
| 178 | #define DEPCA_CLR_MCA 0x08 /* Clear a multicast address */ |
| 179 | #define DEPCA_MCA_EN 0x09 /* Enable a multicast address group */ |
| 180 | #define DEPCA_GET_STATS 0x0a /* Get the driver statistics */ |
| 181 | #define DEPCA_CLR_STATS 0x0b /* Zero out the driver statistics */ |
| 182 | #define DEPCA_GET_REG 0x0c /* Get the Register contents */ |
| 183 | #define DEPCA_SET_REG 0x0d /* Set the Register contents */ |
| 184 | #define DEPCA_DUMP 0x0f /* Dump the DEPCA Status */ |
| 185 | |